Question about Honda VT 1100 C2 Shadow Sabre Motorcycles
...kickstand switch, but could the clutch need bleeding? Hi Unlikely that the clutch needs bleeding unless she lurches forward when she dies It will be side-stand, clutch or neutral lockout switches or ...
Question about Honda VT 1100 C2 Shadow Sabre Motorcycles
bike and I unplugged two of the plug wires and then forgot to plug them back in. I started it took it down the road it was popping but didn't think anything of it cuz it always does when I first start
...kickstand that goes into a slot when the bike's weight is on the stand. If not for this tang, you could push the bike forward and it would fall over. The "tang" locks the bike from moving forward or ...
Question about Motorcycles
...kickstand up the bike starts and runs fine, but if I don't have the kickstand up the bike won't start at all. A friend of mine has a bike similar to mine and his will start while the ...
Question about Motorcycles
...bike to kickstand down and let the clutch out see if it does the same thing you're describing iclean your kickstand this should be like a little pen the part that you push in to make the point, now ...
...kickstand still down. If the bike turns off when you put it in gear and your kickstand is up, not down, you need to have the kickstand switch and wiring for the switch checked. It may be ...
...kickstand is down the bike turns off even in neutral.2003 Buell Blast . The neutral witch is behind the clutch and as long as it is switched on the bike will not run unless you defeat the kickstand ...
kickstand kill switch inop just went to get bike inspected and was told would not pass due to kickstand kill switch inop. tested switch by ohming out (good) traced wires to relay on right side of bike
...kickstand that prevents bike from being ridden with the kickstand down. The engine will turn off if the bike is not in neutral while the kickstand is down. Make sure your kickstand is all the way up. ...
Question about Honda VT 1100 C2 Shadow Sabre Motorcycles
...kickstand down while on slight grade, front brake on,clutch pulled on and now it will not start. riddle me this. You may be low on fuel, and none is reaching the fuel valve, but a more likely answer ...
118 questions posted
Usually answered in minutes!
138 Questions
77 Questions
69 Questions
36 Questions
32 Questions