2001 kawasaki KMX 125 "pulser coils test" Questions

...pulser coil plug(S) follow manual test procedure for testing stator coil, and pulser. check ign coil,make sure grounded to frame,clean rust, check resistance readings(manual) or test system w/ known ...

...pulser? The best way is with a peak reading volt meter set on dc volts. Has to be a peak reading meter a standard volt meter will not read. Pulser coils typically put out 2-7 vdc at cranking

...pulser where the wires come out of the motor (Unplugged). Forget the 3 white, they are only for charging, The other 4 are the pulsers, 2 for each. I don't have the color codes, But they should both ...

turns over but not firing turns over but not firing first check primary side of ignition coil if no current flow there ,test cdi box, if no current there test pick-up coil or pulser coil

...test with a basic multimeter. 2. is the pulser sending a pulse - also can be tested with basic multimeter 3. is the CDI blown? - swap out to test 4. Is the Coil blown? - can be tested with multimeter ...

at the coils on the orange/white wire. Also check for battery voltage at the CDI module on the orange/white wire. If voltage is present the most common failure is the signal generator (aka pulser coil

...pulser coils; the output of the pulser coils would be very very low ACV; it would be preferable to use an analog/needle type multitester for the flickering pulser voltage; the CDI also needs a "go ...

No spark. Tested output of pulser coil with pek volt meter and got areading of 2.5 volts. The voltage out of the motor between the two output wires was 10 volts which seems to low to me. They are ...

...awhile the bike died and would not restart. 2005 ktm 450sx, check spark none, replace coil and pulser coil still no spark. there are only two pieces lefted to repalce stator or cdi. what would ...