2003 Suzuki VS 800 Intruder "solenoid clicks starter engage" Questions

is clicking , the problem is that the contacts inside the solenoid are burnt and not making a connection. Replace the starter solenoid and your motorcycle starter will engage the way it is supposed to

...solenoid clicks the button is good. If not check the two colored wires going to the solenoid for continuity with an ohm meter when you press the starter button. If no continuity, take apart and clean ...

...the two points at the solenoid, if the starter truns thn its the solenoid switch which is faulty ..if it doesnt still turn, thn you will have to remove the starter and overhaul it. Hope this

starter solenoid? I would suggest the solenoid is duff or incorrectly connected.. A starter system works by switching on the ignition, pressing the starter button, the solenoid closes and allows power

...starter solenoid is not activating the starter drive or jack shaft then the starter would spin freely and whine. If you have a bent shaft or otherwise that will stop gear engagement when you try to ...

starter solenoid was just clicking but not starting, replaced solenoid but have the same problem, could it be the battery? Certainly. Battery voltage causes the starter solenoid to move out to engage ...

solenoid just clicks and starter doesn't engage.We removed engine to paint frame started worked then but when we reinstalled engine starter doesn't engage.Starter motor was checked and was good.There ...

...clicks at relay. Battery is good Take a look at the starter solenoid. There are two larger wires, on the back. One from the battery positive, (main hot wire), the other goes to the starter motor (If ...

Solenoid clicks when i press the start button. I've now replaced the solenoid and the brushes in the starter motor but the solenoid now clicks rapidley and still nothing!! check your battery. even

...starter side of the solenoid. If it engages then the the battery cable from the battery to the solenoid is bad. To test the relay, put 12 volts dc on the trigger side and the relay contacts should ...