getting fuel, the fuel pump may not be delivering the fuel to the carb or the carb may not be allowing the fuel in due to a stuck float valve or a dirty jet. I'm leaning toward a dirty jet or bad fuel
Question about Suzuki RM-Z 250 Motorcycles
carb and it runs but stalls and will not idle sounds like the float is not working properly , could also be the jet. would be a good idea to buy a carb kit, not very expensive and save a lot of grief.
...minutes then we shut it off and it will not crank back. The spark plug seems dry. compression under 110 get's is questionable. check your crank bearings and seal. also clean carb and check float ...
...solve your problem first i would replace the gas and drain float bowl ,then check flow at petcock if that doesn't do it pull carb. clean the jet's and transfer port's and replace the spark
Question about Suzuki RM-Z 250 Motorcycles
...carb would be great help manual does not have one. Thank You I am not certain exactly what bike you have so consider the diagram below as generic. Chances are the float needle is sticking open a bit. ...
...float bowl. With the carb inverted, take off the float bowls. Take off the gasket. Use a vernier caliper or an accurate device to measure from the carb body to the top of the float block. Here is are ...
...carb. THe float bowl is empty. Need help finding the source of the blockage & how to clear the blockage. remove carb...remove float and float jet...blow through with compressed air. Check float ...
carb body , Sticky float, tap the float bowl to see if it stops and frees upCheck carb bowl for dirt in float valve or wear on float valve or seat or seat o ring, make sure the float is still floating
...float chamber and carb cleaner in areas I could reach by removing the Vacuum chamber cover and jet I have fuel pouring from one of the air vent tubes. What Did I do wrong? (other than trying to clean ...
Question about Big Motorcycles
...the carb, take off the bottom float bowl on the carb. Then while holding the carb upside down, you want to set the floats level. You will have to bend the little tab on the float needle to do
93 questions posted
Usually answered in minutes!
60 Questions
0 Questions
2 Questions
1 Questions