2008 Suzuki GSX-R 600 "key release amp" Questions

...release it. I checked all the possibilities of battery, the three kill switches, the fuses, starter, and even replaced the tip over sensor, I tried resetting the computer by switching the key on and ...

...release no matter what I try (push key & turn left; don't push key & turn left). Battery is dead. I have Mustang seats that latch tight. 04 Roadstar Silverado. Have you tried the opposite way ...

...release ? I cannot get the ignition key to work in the latch. Thanks for your help. Jim yes the keys are for both , to release seat put pressure on seat then turn key seat latches often use a sliding ...

...release starter button, starter keeps spinning but is not engaged. I can turn off ingnition key but starter keeps spinning, Only way to stop is to remove ground from battery. Re-attach ground to ...

...key fob reception is not connected. You also need to squeeze the clutch lever to allow the engine to engage also...new safety feature i think for 07. To actually get to the diagnosis mode (to read ...

key on and the bike started, after shutting it off for 5 minutes the bike will not start now and the fuel pump is not running when first turning the keys on. also the engine light is on Pull any error

...the seat towards the gas tank to release the rear tab that locks the seat in place at the rear by the fender... I hope this information is helpful. use your ignition key on the left side of the ...

...release. the new digit (a) will replace the current in odometer window.Enter second digit (b) with LEFT signal switch.Repeat until PIN is set.Once PIN is set (either new or old PIN), to disarm ...

...key is on and the solenoid is in the off (or rest) position - all electrical works. When you energize the start solenoid, you need all the power you can get to run the starter - everything electrical ...

...key OFF to complete housekeeping, allowing the rider more opportunity to release the throttle grip, so the throttle control can return to true zero before the ECM poweris shutdown. This should ...