1990 Yamaha FZR 1000 "broken stick throttle" Questions

...how do i fix most throttle sticking problems are caused by either a kinked or broken cable or the cables routing through the frame is being caught on something. Thats my experiance. Hope this ...

...broken wires get jammed inside the protective steel wrap.This usually happens around the cable guides at the thottle or carburettor ends,pull the carb throttle slide,twist on the throttle and check ...

...broken. The rear brake light switch is a pressure switch located in a tee fitting in the metal brake line going to the rear brake from the rear master cylinder. They do give problems but not very ...

...throttle cable from carb. linkage to determine if cable is binding/broken and see that linkage moves smoothly.lubricate linkage.'slide' type carburetters were popular in the '70's sticking slides can ...

...broken strand that is snagging on the coil shaped section of the sheath. If not, then you have an issue with the slide not freely traveling in the tracks, or the main jet needle not smoothly ...

...throttle sticks at full. Problem is in carb. Sounds like the return spring got squashed. Take the top off of the carb, free up the spring and, if it isn't broken, reassemble carefully. Try it ...

...this up pls. cheers. The throttle sleeve is either mashed or broken. They aren't too expensive though. Just take the grip off on the throttle, then loosen the screws for the sleeve and

broken), or an unlubricated cable, a piece of debris in the carb between the slide and the carb body, or the spring is whacked. Unscrew the top cap, slowly pull the cap, spring, and slide up and check

broken You will need to remove and replace it...this happens often on these bikes, the throttle gets sticky after a while too...Look closely at how they are routed, most often heat causes them to melt