2000 Yamaha DT 125 R "gear shift indicator switch" Questions

...shift switches (gearshift switches) simultaneously. The "N" on the gear position indicator starts blinking. Step 3. Within 5 seconds after turning the ignition switch to "ON", push and release the ...

gear, doesn't shift properly. you did not list a TTR50 so I picked the TTR125, could you still answer my questions on a TTR50 thanks! If the bike starts when it is in gear that would indicate that the

...shift one gear lower each time you press it. A word of caution... This bike is more powerfull and responcive than just about any bike the same size and many other larger bikes. You do not have much ...

...gear, it dies. It reacts to the shift, not the clutch. Is it electrical? Mechanical? I need help troubleshooting. thanks. With the engine off, put it in gear and pull the clutch lever. If the bike ...

...Shift the tranmission into any gear and the meter should read infinity or a very high ohms reading. To replace the neutral indicator switch, You'll have to loosen the final drive belt and remove the ...

...gear shift after a few times it will start back again. First guesses are a weak battery or starter relay going bad. Next time it does it, keep pushing the start switch rapidly and see if it catches. ...

...switch my gears from 1st gear to 2nd gear there is this abnormal noise that sounds like the gears are not lubricated enough or something but I just recently changed the oil and filter. what can this ...

...gear to pull away it seemed to be between gears and took a good prod, also made a not so nice clonk and noise. Now seems to select gears ok, though not been far since. Not sure what to do, or if just ...

...shift. The contact point wears over the years till contact is lost. You should be able to start the bike if the kickstand is up and the clutch is in, thats how in gear restarts are normally ...