...blaster 4 wheeler. Starts fine but bogs down when you throttle up it seems to be loading and will never throttle all the way up. It acts like it's not getting enough fuel. I cleaned the carb, and ...
Question about Yamaha TW 125 Motorcycles
...carb... i can't seem to figure out why my 2004 blaster 200 won't idle properly. i cleaned the carb and replaced the spark plug. it revs fine but when it goes down to idle it just dies. any help? This ...
Question about Yamaha TW 125 Motorcycles
carb cleaner over night). Fuel turns to varnish in just a few months. good luck i need some help my 02 blaster will not idle and i dont even know how to fix it if some one will give some suggestions i
...blaster will idle all day long soon as you hit the throtle it dies try cleaning carb and see if the choke is hung up also make sure it has the right plug ngk b8es check the rev limiter it is on the ...
...can i do to get it back to it's prime!!! Replace the reeds, Clean the carb jets and adjust mixture screws. Please rate this a fixya how do i adjust my carb on my yamaha blaster with 30 over bore ...
...blaster 200 bored 30 over. In neutral revs fine. Once you put it in gear it bogs. occassionally cleans out but still wont go to full rpm. Cleaned carb and used new plug. check the compression and if ...
...BLASTER RS12 will not start, would the carburettor starter stop it starting if it is not working and is there anyway to test it ? the plug is sparking and the petrol is getting to the carb but not to ...
blaster 200 sat for4 a year i drained the old gas, dropped the float bowl and cleaned it out... it starts on either but dies once the either burns off. dosent seem to be getting fuel... HELP!!! Hi, If
..., the gas in the carb has turned to varnish and the jets are glogged up. Take them apart, clean with PB Blaster and carb cleaner. Then use an air gun to finish cleaning the jets and carb
...blaster 200 to idle properly. I changed to plug and cleaned out the carb. it revs fine but when it slows to an idle it just dies off. help?? simple just turn the idle screw in 1/4 of a turn mate and ...
24 questions posted
Usually answered in minutes!
16 Questions
10 Questions
14 Questions
11 Questions