2001 Yamaha TW 125 "carb adjust" Questions

...up what could that be any help most welcome ALWAYS have a fire extinguisher at hand when working on carburetors. Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any ...

...in 4th and 5th gear, 1st, 2nd and 3rd are as they were. tyres are at correct psi, chains good, and carbs n bike is coming up for 19000 miles, oil changed about roughly 60 miles ago you say there is

...adjust idle speed -checked fuel level -checked fuel **** -replaced spark plug -checked battery Also strange thing: There is a hose connecting the fuel drain pipe (bottom of the carb) with pipe in the ...

...You have to adjust the jets on the carb, theres a high and low jet, Turn them both all the way in ( dont force them) just turn until they stop, now losen each one in 1/4 intervals and try running

...Your cable might be too tight & lubricate the cable. If that don't help, the slide in the carb is stuck open, you will need to reset it. Try moving the cable around by hand, sometimes that ...

...in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ). Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then ...

hi how do i adjust the float to get more fuel to my carb on my yamaha tw 125 Hi, you should slightly bend the float tang, so it will push the needle "later".

...low rpm. At high rpm in any gear it cuts out and sputters like it isn't getting the gas. I swapped carbs with my 87 and it does the same thing. I swopped brains with the 87 and it still does it. I ...

...carb directly connected to the slide just adjust each cable accordingly and achieve the same as above. make sure you have a little freeplay at the throttle when you are done. you can adjust that by ...

When syncing the carbs on a 1991 Honda CBR 600 F2 there are only three adjusting screws to adjust them but there are four carbs on the bike. So how am I to sync the carbs with only three screws? To ...