Question about Yamaha V Star Classic Motorcycles
...SET FLOATS AS CLOSE TO WHAT THEY WERE WHEN YOU REPLACED IT. INSTALL THE BOWL AND PUT THE TUBE ON THE DRAIN. OPEN THE BOWL DRAIN SCREW WHILE HOLDING THE TUBE UP BESIDE THE CARB. WHEN YOU GET THE TUBE ...
Question about Mikuni Motorcycles
Float level setting on Mikuni carb, 30-32 DIDTF Mitzi L200. Remove the float bowl on the carb. Hold the carb upside down, the set the floats level.
set my float to 22.0 +- 1.0 for a Mikuni carb. To set floats, drain the carbs, pull the carbs from the bike invert and remove float bowl. With the carb inverted, take off the float bowls. Take off the
...gas to the cylinder at all A couple of possibilities- - Float is corroded and not floating - Valve either gummed up or worn and stuck - Float level not properly set Typical float valves Typical ...
Question about UM Motorcycles
Float Level - YouTube ? 2:06 https://www.youtube.com/watch?v=aiexehn33kg Oct 9, 2013 - Uploaded by Mike Nixon How to adjust a carburetor's float level. ... Motorcycle Mikuni CV Carburetor Cleaning for
...float chamber gasket off, set floats to 21.4 - 23.4 mm (0.84-0.92 in.) If the float chamber gasket is still on the carb, reduce the measurement by approximately 1mm. As a side note, I went to an ...
...float if equipped is set too low, and/or air leaking somewhere. If you made no other changes (new exhaust system for example) and it ran fine up until a problem required a rebuild, double check your ...
Question about Big Motorcycles
...the carb, take off the bottom float bowl on the carb. Then while holding the carb upside down, you want to set the floats level. You will have to bend the little tab on the float needle to do
62 questions posted
Usually answered in minutes!
177 Questions
134 Questions
90 Questions
69 Questions
56 Questions