Ford 8N Tractor "coil" Questions

12 volt 8n ford will not fire, no spark at first plug I get 12 volts to the resistor before the coil, 10 volts across the resistor but no volts to the coil. The resistance of the wire from the ...

8n (front mount distributor)seems to be frying coils, one day working just fine, next doesn't spark at all, New condenser, plugs, wires, rotor,points, distributor cap. Replaced coil last time seemed ...

1952 ford 8N tractor will not start. New plugs, wires, distributor and coil. Engine turns over but no spark comes to spark plugs DID YOU REPLACE THE ROTOR BUTTON IF SO THE YOU NEED TO MAKE SURE THAT ...

won't start !! converted to 12v ,new starter and solenoid installed along with new coil,points,roto cap now no spark to plugs 48 ford ,front mounted Cranks? Check voltage to + side of coil,first. ...

...and closing correctly. Next make sure you are supplying 12 volts to the little terminal on the coil, if 12v is being supplied pull the coil wire out of the distributor cap and hold near a good ...

why wont my 8n start it gets voltage to coil Check timing ,plugs and if it's getting gas. Does the voltage "pulsate" when you crank the engine over.? You should see the points causing the primary ...

Have new plugs, wires, cap, coil, rotor points, condensor. Still no spark Check for power getting to the center top connection at the coil. Are the points opening? Are they fully closing? Check for a ...

...selonoid 8n tractor need to figure out how to wire my selolnoid u can run a hot wire strait from coil to + side of ign switch, be sure and put a ballast resister in the wire to keep from burning ...

I have 1952 ford 8n and will run 5 minutes then start missing and hesitating could the coil be getting hot? Its 6 volt coil with internal resistor but tractor was converted to 12 volt. Runs good till ...

where dose a coil on a car get its juce from Let me see if I understand your question...  You asked, (Where does a coil on a car get it's juice from? Correct?arorWell, Let start out by ...