Jacuzzi Bath Perfecta EZ33 959 White round high-performance toilet - Answered Questions & Fixed issues
Tank has slight wobble after installation
you need to tighten the nuts under the tank. the tank is not even.
The best method is hand tight the nuts to approximately same pressure on all 3 nuts. then use socket ratchet, one turn each,one at a time, till the tank stop rocking. stop right there. flush the toilet, check for leak. tighten as needed.
make sure all 3 nuts have even pressure.
12/24/2012 1:07:56 AM •
Jacuzzi Bath...
•
Answered
on Dec 24, 2012
•
1,310 views
Can't get enough water in toilet bowl to flush the waste
Adjust your tower to let the bowl fill up more.....google your problem if you dont understand...depends on what kind of tower you have....should have teeth on the tower itself to make it fill more...try pulling up on the float...
3/24/2012 3:57:56 AM •
Jacuzzi Bath...
•
Answered
on Mar 24, 2012
•
470 views
Tank not holding fill level...
Most likely, you do not have a good seal on the flapper valve at the bottom of the tank. To confirm, try this:
Turn off water and flush toilet. Then lift up the flapper valve and put a light coating of vaseline on the mating surface where it contacts the toilet tank when closed.
Turn water back on and see if it continues misbehaving. If that fixes it, it was a bad seal. Usually that is all it takes.
11/6/2011 12:16:34 AM •
Jacuzzi Bath...
•
Answered
on Nov 06, 2011
•
756 views
Tank to bowl leaks
Turn water supply line of to toilet. Flush and hold handle down to drain water from tank. Take lid of tank off and use a towel to soak up the rest of the water inside tank. Remove nuts on bottom of Tank bolts. Lift off and lay down on its side. Remove the rubber or sponge type gasket that is on bottom of the tank that covers the nut from standpipe assembly. Buy new gasket and install back on bottom of tank over Nut for standpipe. Put tank back on toilet bowl. Install bolts and tighten. reconnect water line and turn on.
9/1/2011 1:07:49 PM •
Jacuzzi Bath...
•
Answered
on Sep 01, 2011
•
276 views
Not finding what you are looking for?