20 Most Recent Saniflo SaniCompact-48 SaniCompact One Piece Macerator Toilet Questions & Answers

Use the power cable that came attached to the motor to wire to a fused spur.

Check the holes rubber ring or change the whole holes

Here is a nice link for your saniflow maintenance.http://www.plumbteamltd.co.uk/sanifloguide.htmlThis will may help.Be careful blades are very sharp.

It will dissolve however it will take many days you can't wait so you need to go rent or buy or borrow small rooter route to get it out. It's not a bad fix so don't let someone tell you different. You can fix your self. Good luck.

Got a blockage in your out pipe, could be a rag or a big tur. You need to snake out the main drain going out of your house.

this is a common problem mainly due to paper being put in them the key that holds the blade in position has become disenged and needs to be replaced

sounds like you need septic tank pumped out. or there is a clog in main line if city sewer. hope this helps. duane.

Some wall mount toilets can have the cistern fitted on the other side of the wall the bowl is mounted to so it appears 'Hidden'. Your float valve adjustment will be in there.

I know absolutely nothing about the Saniflo system other than the very basic working principle but logically there must be a vent or an airbreak between the macerator/pump unit and the toilet bowl or the pump would tend to create a depression in the container and draw water from the toilet bowl...

That sounds like the issue. Saniflo provide them, so contact them for a free one. Article says it is inside the pressure vessel.

Saniflo Saniplus Capacitor, 45 Microfarad - SanifloStore.com

https://saniflostore.com > Saniflo-Saniplus-Capacitor-45... This replacement is slightly more involved as you have to open up the pressure chamber, once there though it is two small screws on junction box to release ... More here https://www.google.com/search?q=replace+saniflo+capacitor ..

Contact saniflo , they will send an engineer.

How much water does the system use? All models in the Saniflo line are low consumption. The SaniPlus, SaniAccess (2 and 3), SaniBest Pro uses 1.28 gallons (4.8 liters) of water per flush.

Saniflo Installation Instructions

Videos as well https://www.google.com/search?q=How+much+water+should+be+in+the+bowl+of+a+saniflo+best+pro ..

Check flapper for leak and or worn flush valve