20 Most Recent Saniflo SaniCompact-48 SaniCompact One Piece Macerator Toilet - Page 6 Questions & Answers

Here is a nice link for your saniflow maintenance.http://www.plumbteamltd.co.uk/sanifloguide.htmlThis will definately help.

Very carefully. Call the mfr to get clearvinstructions.

let more water in adjust ballcock

you have a blockage in drain system. also make sure the air vent is ok.

You will need to adjust the level of the float that shuts off the water inlet valve it is to low.

Hi,
Those flappers need to be replaced regularly. They are available at many store like Home Depot or Lowes Make sure to get the make of your toilet and maybe even the number of the tank. It is stamped on the inside of the tank.
Then buy a new flapper and replace it, it is easy!

heatman101

Replace the the button switch it has or is going bad. You can try taking it out and cleaning the contacts but this hardy ever works.

It sounds like the valve is not shutting off fully as it must.
If the instructions explain how to flush the valve before you put it into service, do that again.
Otherwise, I'd take it back.
Gary

After turning power off to unit, open unit and locate float switch. Switch may be stuck in up posistion which will cause unit to run constantly. If float switch is down than switch will need to be replaced.

More than likely the turbine in the pump is probably lost its seal. When it was pulsing, that was the turbine turning and friction was causing the pulsing. Now that the friction of the seal is lost, it is causing it to take longer to pump.

out of the vent where.

Is the float set correctley if not it may be overfilling and the toliet will flush itself at a certain level.