Top 20 Life Fitness 9500RHRT Recumbent Bike Questions & Answers

tes the charger in another receptacle wall, if is ok , test the receptacle wall if is open, reset the circuit breaker . if his system use batteries replace, or see if they are o.k use alkaline only. Other is everything is o.k see if the board is fault or look for some wires loose, or disconnect. Let me know Blessing [email protected] cell+whatsApp: +50588611441

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Please have your model and serial number available.

you can request a copy of user manual by post or fax from Icon by filling this online form. Mention FreeSpirit 859 in the model. The electronic format is not available for this mode.

That component is a capacitor and not a battery, The battery is locate on the back portion of the bike frame, tilt the bike to its side you'll notice a plate remove the 4 screws flip the plate over. On that plate is the battery it has 2 leads red ( + ) and black ( - ) leave them on until you purchase the new battery. After receiving the Battery their is 2 screw that attach the battery to the plate and replace with new battery reverse procedure to install.
You may purchase this item from National Gym Supply Part # LC001.5 cost $19.80 tax and s/h Call them @ 1-800-496-7278

Do you consider yourself as an above average do it yourself person?

The difficulty level for this fix is 6/10.
===

Your are working with electrical part. Please disconnect all power cord power before service this unit.

===
The company that I deal with is the past is call http://www.sportsmith.net

Please use the following pictures to locate the parts that need to inspected and clean.

Lifecycle 5500 use an alternator (just like your car) to increase and reduce load on the drive system.


The key is to inspect and clean the parts the driven by the alternator.


Example:
Check for loose electrical connections.

Check for worn belt

Check the bottom for broken part (rubber belt powder / fragment)

take your time to do the preventive maintenance.

Check the two long bolts,nuts and cap on this kit


Link HERE

Check for free play / loose / worn parts.

DO NOT lube rubber parts!

Do not use excessive oil on the moving parts.
Lube the crank. Wait for one hour and wipe down the whole crank.

Please email me if you need more assistant on this Life Cycle 5500 bike.

If this unit has not been used for that period of time then the 6v batt has died ans needs replacing call National Gym Parts @ 1-800-496-7278 to order part# LC001.5
HERE IS THE PROCEDURE TO REPLACE THE BATT:
Tilt the bike on its side, remove mounting screws securing the battery to the bracket. Remove the battery just enough to access and disconnect the black (neg) wire from the (-) terminal and the red (pos) wire form the (+) terminal. Replace battery and reverse procedure when installing battery

Click here then click on LC95RS-0109-04 Parts list and the wire schematic is on the last page.

Inside the side panels there is a 6v @ 2.5 AH batt check this with a multi meter any thing less than 6v replace it go to gymparts. com they will have this batt.

On the bottom the bike frame their should be s# plate. If you need to replace the battery you need to: first remove the foot pedals,then side panels.

A 6v @ 2.5Ah battery should be in the frame
they sold run about $20.00 to $27.00 plus S/H

sounds like the keypad is not functioning since this is one of their older model I recommend call Life fitness and see if parts are available their # is 1-800-351-3737 they will probably will ask for a s#

Yes you do have to take not one, but both sides off: First take off left and right pedals, a 14mm or 9 l16 end wrench will do the job. Then you will find specific holes where the screws that hold the side panels are I think they are # 15 or 20 torque ( star confiuration). This will expose the frame blow all the debris out. Last ,but not least you will locate the battery behind and below the alernator two phillips heads screw hold the 6v @ 2.5ah battery in place,then replace the the battery, and reassemble the unit. This sholud not take more than 30 min to do.

Usually a faulty lower circuit board - remove and replace or call a local service tech.

I am asuming you tested the drive motor, did any burning smell eminating from the motor? We do have a short in that board if that is still on your bench I would trace where those conponents are going to and use if you have a portable Dc power supply with voltage and current displays I would set power supply at a lower voltage ( 1v to 2v ) take grd lead to grd and use red for the purpose of isolating the short could be in the bank of IGBT's Caps shorted etc depending on location of damage.

YOU CAN PURCHASE AN MANUAL FOR ABOUT $20.00 TO $25.00 PLUS S/H FROM THESE PEOPLE : NATIONAL GYM SUPPLY 1-800-496-7278 THEY WILL NEED M# AND SERIAL#

You should check your battery-it must be putting out at least 6 volts to get the computer started up-depending on the era there will be a battery near the bottom frame-you will need to remove on of the side covers to reach it-

the display quit working on the 9100 seris

Hi
We had exactly the same thing. If you take the covers off you will find a black battery pack in the bottom. It is about the same size as a cordless drill battery. We got a replacement from Maplins - cost about £10. It works perfectly now.

You have to start pedaling to get it to start up, some times you have to pedal pretty fast to get it to start up

To start open the door at the bottom of the control panel and remove the 9V battery. Eventually replace it with a fresh batttery to reset the control board.

If that does not fix the problem the control assembly should be replaced, this is sold as a single part and is normally considered not serviceable at component level.

Change the battery. It is a 9v battery behind the small door on the back of the display panel.