Life Fitness 9500RHRT Recumbent Bike - Answered Questions & Fixed issues

tes the charger in another receptacle wall, if is ok , test the receptacle wall if is open, reset the circuit breaker . if his system use batteries replace, or see if they are o.k use alkaline only. Other is everything is o.k see if the board is fault or look for some wires loose, or disconnect. Let me know Blessing [email protected] cell+whatsApp: +50588611441

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH Please have your model and serial number available.

Change the battery. It is a 9v battery behind the small door on the back of the display panel.

you can request a copy of user manual by post or fax from Icon by filling this online form. Mention FreeSpirit 859 in the model. The electronic format is not available for this mode.

That component is a capacitor and not a battery, The battery is locate on the back portion of the bike frame, tilt the bike to its side you'll notice a plate remove the 4 screws flip the plate over. On that plate is the battery it has 2 leads red ( + ) and black ( - ) leave them on until you purchase the new battery. After receiving the Battery their is 2 screw that attach the battery to the plate and replace with new battery reverse procedure to install.
You may purchase this item from National Gym Supply Part # LC001.5 cost $19.80 tax and s/h Call them @ 1-800-496-7278

Click here then click on LC95RS-0109-04 Parts list and the wire schematic is on the last page.

Usually a faulty lower circuit board - remove and replace or call a local service tech.

If this unit has not been used for that period of time then the 6v batt has died ans needs replacing call National Gym Parts @ 1-800-496-7278 to order part# LC001.5
HERE IS THE PROCEDURE TO REPLACE THE BATT:
Tilt the bike on its side, remove mounting screws securing the battery to the bracket. Remove the battery just enough to access and disconnect the black (neg) wire from the (-) terminal and the red (pos) wire form the (+) terminal. Replace battery and reverse procedure when installing battery

Inside the side panels there is a 6v @ 2.5 AH batt check this with a multi meter any thing less than 6v replace it go to gymparts. com they will have this batt.

the display quit working on the 9100 seris

Yes you do have to take not one, but both sides off: First take off left and right pedals, a 14mm or 9 l16 end wrench will do the job. Then you will find specific holes where the screws that hold the side panels are I think they are # 15 or 20 torque ( star confiuration). This will expose the frame blow all the debris out. Last ,but not least you will locate the battery behind and below the alernator two phillips heads screw hold the 6v @ 2.5ah battery in place,then replace the the battery, and reassemble the unit. This sholud not take more than 30 min to do.

I am asuming you tested the drive motor, did any burning smell eminating from the motor? We do have a short in that board if that is still on your bench I would trace where those conponents are going to and use if you have a portable Dc power supply with voltage and current displays I would set power supply at a lower voltage ( 1v to 2v ) take grd lead to grd and use red for the purpose of isolating the short could be in the bank of IGBT's Caps shorted etc depending on location of damage.

YOU CAN PURCHASE AN MANUAL FOR ABOUT $20.00 TO $25.00 PLUS S/H FROM THESE PEOPLE : NATIONAL GYM SUPPLY 1-800-496-7278 THEY WILL NEED M# AND SERIAL#

sounds like the keypad is not functioning since this is one of their older model I recommend call Life fitness and see if parts are available their # is 1-800-351-3737 they will probably will ask for a s#

On the bottom the bike frame their should be s# plate. If you need to replace the battery you need to: first remove the foot pedals,then side panels.

A 6v @ 2.5Ah battery should be in the frame
they sold run about $20.00 to $27.00 plus S/H

You have to start pedaling to get it to start up, some times you have to pedal pretty fast to get it to start up

You should check your battery-it must be putting out at least 6 volts to get the computer started up-depending on the era there will be a battery near the bottom frame-you will need to remove on of the side covers to reach it-

Hi
We had exactly the same thing. If you take the covers off you will find a black battery pack in the bottom. It is about the same size as a cordless drill battery. We got a replacement from Maplins - cost about £10. It works perfectly now.

How do I fix error 6 on my treadmill? E6 Error: Controller malfunction. Resolution: Ensure that the cables connecting the console and the controller are secure. If any of the cables/connectors appear loose, completely power off and unplug the treadmill before unplugging and reattaching the cables.Sep 23, 2021

E6 Error Code: Control Board Malfunction - Spirit Fitness Support

https://www.google.com/search?q=LIFE+FITNESS+T3+ERROR ..