Fagor FFT106 Top Load Washer - Answered Questions & Fixed issues

If some fault causes the anti-over flow micro to be activated for more than 10 seconds, the machine will stop and beep as follows: 4 beeps Pause 4" 4 beeps pause 4".........and so on. This means error code F4. Possible causes: - Excess water intake. - Anti-over flow safety proximity micro switch has been short-circuited: It does not disconnect, either electrically or mechanically

Perhaps the pump has failed, or the impeller has dropped off. It happens.

I'm sorry, but as an AI language model, I don't have access to specific passwords for Fagor LM-60 washing machines. However, in most washing machines, the water level is controlled by a pressure switch or water level sensor. If you want to reduce the water level, you can try adjusting the pressure switch or replacing the water level sensor. It is important to note that tampering with the settings of your washing machine can be dangerous and may cause damage to your machine. It is recommended to seek the assistance of a qualified technician or the manufacturer's customer support team for specific guidance on how to adjust the water level in your washing machine.

You will probably find it has a crack in the surface of the element and is leaking to earth. That is why all electrical appliances must be earthed with a three prong plug or hard wired. Replace the damaged element.

suspect the door switch

if you have an electronic panel, it could need replacing.

https://www.manualsearcher.com/fagor/f-2810/manual https://www.repairclinic.com/Video/Video-Landing/2920-11/Top-Load-Washer-Won-t-Start-Washing-Machine-Troubleshooting

Try unplugging it for 5 minutes to reset.

Unplug let set one minute then plug back in.

What does not "spinning" properly mean?

Mice are helpful little creatures... Mostly if you can take the top off the machine yourself you should be able to replace the hose yourself.

where did u get it? if u remember plz make sure to have the receipt and replace it or u can try and make thm fix it I hope this useful if it isn't plz contact us at knightsrulefixya.com.au thankyou

Hi,I cant be a hundred percent shore,but I think that it means ( fuel voluem regulater control curcuit low )I hope I am not steering you in the wrong direction,I have a code gide and this is it if im reading it write,all the best.

go to the following sites www.ask.com/fagor_shows_00_and_long_beep/ www.infolinks.com/fagor_long_beep_00/ www.wikipedia.org/fagor_long_beep_error_00/

Belt is worn. Replace belt. GOOD LUCK FRIEND.

Possible that the inlet flow is low, Clean the inlet filter, check the inlet flow. Check the drain filter and if this was clogged, then the chances are that the valve must be removed and cleaned.

Go to fagor.com and get repair manual info. parts diagrams etc..

Just had same problem... Just loosen the 2 screws at the bottom and it will open easy . Use an Allen key if you don't have a French Allen key. Mind the water that will come out have a dish ready underneath the opening. Ian

Click on : Door locked