Maytag Bravos MTW6600T Top Load Washer - Page 3 - Answered Questions & Fixed issues
Wont fil with water
The screen on the water inlet to the machine may be plugged. Take the water hoses off at the machine end to see if there is a blockage. If that isn't it the solenoids that open the water valves may be stuck or not working. The timer operates the solenoids.
Spin cycle is loud
Main bearing needs replacing or something caught between inner & outer bowl.
UL bravo error code
Unbalanced load? Don't over stuff the washer. The load sensing moves the drum back and forth at the start. If it can't balance the load it will err.
10/16/2013 7:15:50 PM •
Maytag Bravos...
•
Answered
on Oct 16, 2013
•
1,025 views
Constant out of balance on washer
Check the inter tub ring you should hear water when you spin it by hand if you dont hear water replace the spin tub balnce ring it must be cracked or has a hole in it and leaked out the fluid this is a counter balancer when it gows into the spin cycle h Tech AL Wojo
Noisy in spin
early model that bearing goes out in , but 1300. to replace with new machine i fixed mine very happy i did
Every other wash sd code come on
The SD error code is caused by using the wrong detergent or excessive amounts of detergent.
To correct the issue: Make sure to use HE detergent. Note: Using Non - HE Detergent will cause oversudsing and can damage the washer. Do not use too much detergent.
Note: If using HE 2x - 5x concentrate detergent, reduce the amount being used. The washer will try to run a mini-clean out cycle using cold water and a 5 minute pause to clear the suds. If this cycle does not clear the display and complete the cycle the clothing may need to be rinsed by hand and then rewashed without detergent.
UL light keeps coming on stops spinning
The uL error code is displayed when the electronic control detects an off balance load. This can be caused by overloading, bad bearings in the tub, something between the tub and basket, or an issue with the electronics.
What does it mean f 51
http://forum.appliancepartspros.com/washer-repair/131926-maytag-washer-error-code-f51.html
Fault code F51
Please google your problem, it is quite long! Hopfully you are handy!
Error F 2 all ligths flasing
Check the inlet and the outlet, check the filters on both the ends as if this is clogged there is delay in filling or draining. Also check the flow of inlet to be good, if not remove and clean the inlet filter and the drain filter.check this link for tips:
cleaning vent
Not finding what you are looking for?