20 Most Recent Ricoh Aficio SP 100 e Laser Printer - Monochrome - 1200 x 600 dpi Pri - Page 6 Questions & Answers

Solution is to visit a person who are expert in regard.

Firmware can only be downloaded by someone with "My Ricoh" access. If you have the Firmware or you are able to get it, just create a "romdata" folder on a SD card and dump the .fwu file in the "romdata" folder. Switch your machine off and insert the SD card into slot 2 on the machine controller. Start machine up and select the firmware you want to update. Machine will reboot when its done. If it doesn't than switch the machine off and remove the SD card and power machine up again. Now you are done.

Your Duplex unit is not connected properly. Check the connector and ensure it is all the way in. Also check your Document Feeder connector while you at it.

this is a complex task so i advice you call a ricoh technician to that so that you don't damage any part. thank you and all the best.

kindly ensure there is enough toner in the machine and as well ensure that the transfer belt and unit is properly claen . you can then run the force line adjustment. goodluck

Ricoh Aficio MP2510, 3010 Error code sc542 on Lanier ...

? 6:08 https://www.youtube.com/watch?v=58MQVyjfDyg Sep 3, 2013 - Uploaded by Used .Copier Are you getting Error Code sc542 on your Ricoh, Lanier,Savin or Gestetner copiers? ... Ricoh Aficio 1022 ...

How to reset Ricoh Error Code sc542 sc546 sc548 problem ...

? 2:41 https://www.youtube.com/watch?v=3CnGl1Ytp34 Sep 21, 2015 - Uploaded by Copier Liquidation Center How to reset Ricoh Error Code sc542 sc546 sc548 problem ...Ricoh Aficio copiers : AFICIO 1013 F

There's a video here:

Check fuser

Check the papers. Papers are good then clean the pick up rubbers with ethylated alcohol.

Do not do that if you unknown with the printer model. See the lock clips and screws and remove it properly.

Hey Check the catridge it properly seated or not in no then remove and reinsert. If yes then replace with new one.

Replace the drum and drum wiper blade also use genuine tonner catridge..

542 an error in temprator .may be termistor dirty or defective.termostat or lamp check all.then reset by :c(yellow)-107-c(red.press 3 second)-then turn off and on

CORRECT EDP CODE 885340

Check the setting on the software. Check the tab number copies. If you wish to get some details about Printer repair and Servcie ; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/