Startrac Fitness Products Star Trac Pro S Treadmill - Answered Questions & Fixed issues
My star trac treadmill is reading key dv
I think you mean key dn....This means you have a stuck key on your keypad. See page 55 of the service manual.
http://www.sportsmith.net/images/product_support%5Cstartrac%5CTechnical%20Manuals%5CTreadmills%5CSvcMan%20TR4500.pdf
Eror moter system fault
test the speed sensor, adjust it,clean it, and tight the plug or connector very well.2) Test the input voltage motor, if there are the motor need repair see my personal TIPS for troubleshooting motor3) Test the output voltage board, for input voltage motor, if there are NOT the board is faulty, see the block diagram attached.God bless you
My treadmill will start and you can increase speed
I'm not sure if this will help.
First I was unable to identiy your model. Star Trac makes 'S Series' treadmills and Pro Tread DC (5500 Pro S model) treadmills. Can you be more specific on your model?
Second. I have used Star Trac customer service in the past and they are the best. They are responsive, and knowledgeable, and will provide troubleshooting flowcharts to help you solve your problem. I highly recommend giving them a call.
Hope this helps,
Kurt
As soon as i turn
Sound like your motor control board has shorted to ground thus blowing the breaker I would have that service company back out ASAP!! to check this unit out.
How to reset it
Hi it watches in my humble opinion if you talk about to erase the accumulated information only you must to maintain pressed the keys "star" "0" "enter" and "1" simultaneously and soon loose the key "1" on this mode you entering to Maintenance and with the keys adjustments UP or Down you can chance the values to cero this is for the Startrac Pro S only.
I hope that this information serves to you
Have a nice day
My horizon treadmill immediately stops after 2 seconds
StarTrac 4500 Treadmill NO RPM Error
Probable Cause
A) Damaged or misaligned RPM sensor
B) Display Cable
C) MCB
D) Filter Network
Corrective Action
A) Check the connection of the RPM sensor to the lower control board. Inspect RPM sensor and disc for build up of dirt, dust, or debris. Clean if necessary. Verify RPM sensor and disc are properly aligned. Units equipped with an "optical" RPM sensor (uses plastic RPM disc) should have the disc evenly spaced between the walls of the RPM sensor. Adjust if necessary. Units equipped with a magnetic "cherry" RPM sensor (uses a metal RPM disc) should have the sensor spaced 1/8" away from the flywheel. Adjust if necessary. B) Inspect the display cable for any nicks or breaks. Replace if necessary. If there is no visible damage to the display cable, wiggle the display cable to verify intermittent connection. If by wiggling the display cable, the PWM LED on the lower control board does not flash or intermittently respond, replace the display cable.
C) Refer to the NO RPM Flowchart from the service manual for MCB testing.
D) Refer to the NO RPM Flowchart from the service manual for testing of Filter Network.
Star Trac 4500 Treadmill NO RPM Error Code
Stairmaster quinton 612 plus error code e201
Quinton Error E201
Probable Cause
Grade Over Limit Fault. Turn jackscrew counter clockwise to get within range.
Corrective Action
- Use Up or Down arrows to bring grade into range.
- If error persists, replace grade actuator or VSD. NOTE: Belt and display may continue to be used during fault conditions by pressing clear.
Quinton Treadmill Error Codes E201
Not finding what you are looking for?