20 Most Recent
Life Fitness T3 Treadmill with Advanced Console - Page 3 Questions & Answers
The flooring of the T 3 model sometimes slips and
must calibrate the belt with a allen wrench 5/16 inch turn in the direction of clockwise at a speed of 1.5 to reach 4.5MPH you must turn the key gently to prove that you slide about 10 seconds walk
Stuck key error message
What error code in there? If the console display looks strange or has an error message and is not functioning... unplug the unit to reset the console and then plug it back in.
Do this multiple times if the console error message still appears. If the problem still exists please call customer service. We can't do it more without the exact error code.
Likely the "FET error" appear in this devices, so, this message is caused by the driver transistor on the motor
controller has shorted out. Unfortunately, the fix is replacing the
motor controller.
Its possible that you are interestin in obtain the
owners manual or visit the
FAQs for other details.
Hope helps.
T3 Treadmill Stuck Key
The cause of a “STUCK KEY” error message on the Basic or Advanced consoles. A stuck key error is displayed when one or more keys on the console or activity zone remain actuated for more than 45 seconds.
SOLUTION
Recycle the power. If the key remains stuck, the console will display “PLEASE WAIT” until the stuck key error is displayed again. Determine the stuck key. Replace the console if the problem is a key on the console. Replace the activity zone membrane keypad or the activity zone circuit board depending on the product if the problem is not in the console.
Fet error message
The FET error message is caused by the driver transistor on the motor controller has shorted out. Unfortunately, the fix is replacing the motor controller.
FET Error
FET error is caused by a short in the driver transistor on the motor controller. Unfortunately, the fix for this is to replace the motor controller.
What does FET Error mean on my treadmill
Fet error is caused by the drive component(s) on the motor control board going open circuit or faulty. This is caused by poor power supply or excessive friction on the running belt which in both cases leads to excessive heat build up in the control electronics.
The Motor controller will need to be repaired or replaced and the heat issue resolved.
Hand Sensors Don't Work
If hand sensors are on are on a bar that was installed during assembly, the wires that connects the sensor to the console probably didn't get plug in during assembly. To check this, see if the part with the sensors can be removed. If so the wire conection is usually at the point where you connect the sensor bar or handle to the machine. If they are made onto the console then you will probably have to remove the back of console. Pass this point just a visual check for obvious disconnection only. In not obvious don't touch anything else call an expert.
I have the horizon elite 507 treadmill, how do I
Is it all the way over to one side? Is the belt damaged on one side? If it is damaged you will never get it to Track correctly.
If it is not damaged, then start the treadmill moving at about 2.5 mph, if the belt is all the way to the right then turn the right rear roller adjustment bolt, clockwise one full turn, and wait. did the belt move over a little? if yes the increase the speed to 5.0 mph and observe.
Make small adjustment from one side only until you get it straight.
Not finding what you are looking for?
