Bladez Ion 9.9 Fold-up Treadmill - Answered Questions & Fixed issues
Walking on tread mill is jerky. almost like some one keeps putting the break on
Hi There, have you lubricated the deck lately? does the belt glide easily over the deck with your foot pushing it and the power to the treadmill off? If the belt glides easily with your foot, but not when powered, you're motor control board could be about to fail. capacitors routinely go bad on these controllers over the years. You can find further help by emailing gregATbuyfitnessrepairpartsDOTcom
good luck!!
We have an ION 7.9T
We have done all the above and nothing has worked still got flashing E7! Any suggestions?
It's on however I go to push the buttons to start
replace the battery, and clean the contacts battery, if your model has battery. Adjust the REED switch, clean it, and tigh the connector. Test for open or faulty and replace. see the diagram attached.tight the ribbon cable inside the display, and tight the lower and upper connectorGod bless you
Fuse
normally is 15 amp, for 220vac. However you must see the if you Fuse is 20amps. Read in the metalic size the inscription,you will see the amper Fuse and replace.Remember do not replace one of cristal with some one Ceramic or viceversa.God bless you
My Ion treadmill with LCD screen has an error message
1) adjust the speed sensor, clean it, tight the connector or plugs.see the diagram2) adjust the Reed switch, clean it, and tight the plug or connector.tight the ribbon cable inside.se the diagram3) try to RUN the software calibration for diagnostic, troubleshooting, and fix it.God bless you
My ION tread mill show E1 on screen.\r\nI have
HI,
Ur treadmills motor controlling igbt may be get damaged. may be it become open. working on the electronic side of treadmill is danger for a person who is not aware of about it circuit. all the circuits inside the treadmill is live. possibility to get electric shock. from what u have said above , may be chance to have problem with ur dc motor also. check the same also. remove the motor controlling car and replace the igbt. also replace the transistors in its gate rail. refix the board ,then check. if the igbt get damaged again u have to replace the motor also.
ok
The deck is broken and I need to locate a
At this point their is no secondary market for this product you will have go to BH Fitness and order the deck.
BH North America
20155 Ellipse. Foothill Ranch, CA 92610
T: 949.206.0330
Where is the speed sensor connection located on
Unplug unit the remove motor shroud most sensors are next to front roller/pulley assembly it will be either a black rectangular or cylindrical (reed switch) component adhere to the frame or locate on either end of the drive motor.
Elevation is elevating in the wrong direction
Unless this unit was physically re-engineered,either the rear end incline on some models or from the front depending on the mechanism look closely when you fold it up chances are you will be able see that mechanism thru the bottom cover slot made bigger for the rear wheels to move.
9.9T was on incline8.started jumping unplugged it.
Hello, sorry to say it sounds like you may have to get a replacement elevation motor. The error message "E7" corresponds to the elevation motor being "out of range" as the manufacturer puts it!
What I would do is plug it back in and turn it on again. DO NOT GET BACK ONTO IT. Run it for a while and try to get the elevation back down to 0. If the elevation motor will not move then you definately need a replacement.
Bottom line is that you might be able to continue using it without the motor, but only on zero elevation. To be on the safe side, get a new motor.
Sorrry couldn't help further
Jim
Not finding what you are looking for?
