20 Most Recent Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher - Page 9 Questions & Answers

There should be a float switch inside the dishwasher sometimes these get hung up on the full position which in turn keeps the solenoid from allowing the water to come on. remove the bottom rack and check to see if this is the case. Dislodging the float should fix the problem. If not listen to see if the solonoid Clicks when you turn the cycle to fill position if not it could be either solonoid or the timer. if you hear click and still no water check strainer in water line could be clogged or water is turned off some where.

Try tilting the machine back 45 degrees for one minute 7 then try one of the programmes. Serousely outr Bosch diswasher was firstly not draining water then not taking in water & another forum suggested this odd manouvre & all is fine now

clean filter outlet, pipe is ok ..remove stainless steal screws in side door it should be easy to fit seal then.

To find the model number I have to open the door and faintly etched into the metal surround at the top I can see the model number.

Hi francoisj

There might be water in the bottom pan under the dish washer. first turn off the power, then take the kick plate off and you should be able to feel if there is water in there. If there is remove all of it. you can do this one of 2 ways useing paper towel or my pulling out the dishwasher and tipping it 45 degrees. i recomend trying papertowel first and that should get you going again. hope this helps

brent

is there water in the bottom panel...as there is a float switch there which shuts off the inlet valve

Hi jane_taylor4

The water valve could be bad. Depending on how old the dish washer is there was some prolems with the older water valves. the water vavle is the most common problem with the bosch dishwashers when water will not come in.

hi there,

can you provide the complete model # for your appliances please?

thanks

he there,

sounds like there may be something caught in the drain pump itself.

can you provide me with the complete model # on your dishwasher please?

thanks

Hi nikkij

It is simple to put them back on. the plastic pices fit on the bottom of the hinges. there is a cut out where they fit in. when you look at the door at the bottom you will see the hinges and the cut outs, the plastic pices fit in the cut outs flat side in. hope this helps

hi i think you should go and buy it....................

had the same problem if you remove t20 screw on the left side of the bottom bowl & remove plastic cover this is the drain pump & can block with food or glass particles clean it out & check it revolves & should be ok

I think if u take the left side pannel off u will find the meatering tank clogged up which can not fill up the machine at diffrent levels.

press and hold scrub and delicate at the same time for 3 seconds then let it cycle turn off it should reset.

make sure you dont have water sitting under dishwasher in tray. it can cause pump only to run. If there is water in bottom, look under water valve, there is a float-is it surrounded with water?

the problem is the circulation motor needs to be loosen up take a 5'16 driver open the filter on the bottom and loosen it at froom thr small hole on the left.

Are you saying it overfilled and flooded out, or did it empty onto the floor?

It seem that your DW drain it's water by syphon action. Check if the drain hose is properly installed as a U shape; otherwise the DW can drain itself at any time, leaving the soap undissolved .

does it turn freely??

like if you give it a swind does it take about 6 revolutions then slows and stops?

if it does unscrew it (silver screw) and check the holes and washers and screws etc... as they can break perish.. if you dont know what to look for here i a tip!!

 

go snooping at any respectable white goods store, find the same model that you have and pretend to examin it lol! look at its top arm and see if it mooves as freely as yours!!!!!!

and for same parts etc.. anyhow the point is that if it moves freely then when the pump goes on the water should force it to spin smoothly!

 

however. get your self some dishwasher cleaner!

for the dishwasher! not the dishes! it is like a drain-o for dishes! it unclogs and un clags the pipes etc...

 

good luck!