20 Most Recent Kyocera Ecosys FS-6525MFP Laser Multifunction Printer - Monochrome - P - Page 9 Questions & Answers

There is not a secret service mode.

The eject sensor (ES) does not turn off during paper feed from cassette 1

If you haven`t the CD, you should check the website & download the driver

Remove black cover at rear of finisher, remove silver screw, pull latch toward you, unplug cable.

Corrupted data. clear the all the jobs from the que. restart the machine and this will fix. if not means bad hard drive. I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

try replacing the fuser it says broken fuser heat wire

Main power board

Heat code. You will need to reset in service mode.1087 1087 function find reset fixing assembly and activate. If it comes back you have a bad bulb or a bad thermistor. Could be a thermal switch . It's the fuser assembly.

Try to update the FW

First you have to find out where the paper jam occurs. Check the Rollers and the clutches, then the sensor for the registration and finally the exit sensor. Clean or replace any defective part.

10871087, type 004 and press Start. Choose Execute and press again Start. Restart then the device.

As I know you cannot enter in Service Mode like the MFPs. Only in the Service Settings in Adjust/Maintenance menu.

Try to clean the mirrors in the scanner unit.

You can read the manual for the device and the command center in order to setup the Scan to SMB.

Try to perform a FW upgrade.

Go to Adjust/Maintenance>Service Settings>Enable Repair Unit.

You need to replace the Fuser Unit. Unfortunately for this machine the reset Fixing is not available.

Enter Maintenance Mode 10871087 and press 004 and Start. Then choose Execute and press Start. It will prompt for device restart.