ASUS Eee PC 1000HE Netbook - Answered Questions & Fixed issues

check power switch botton

hello hyjacker this post and OPS other identical post on why F2 repeats, this is COMMON !first take out that relic and bad large battery.run on AC pack only, still dead??http://pcdied.com/dead-PC.html the PC is now 9 years old the RTC COIN CELL BATTERIES, mostly do not go past 7 years, seen 10 happen, but is not PAR, life span is 5 to 7 years.! facts. so replace that first, then reset bios next.and test on AC Pack only, until the PC runs right again do not use the useless 9 year old HUGE BATTERY, oK? then make sure boot order in BIOS shows HDD , in the list. or the HDD is dead. the coin cells dead will cause many PC to stick at BIOS screens, after all it cant find the boot order configurations with that battery dead. once that is cured, you can boot windows if the HDD still works. on some pCs you can hit F2 and it loads BIOS defaults and boots. but after powering down, all that is lost and all this above repeats. the service manual on your PC covers this.but I can not find that manual anywhere... how to replace your RTC Coin cell.? here it is, remove any hatches to reach it.RTC is on the bottom see yellow blob this is your exact mobo.this is the bottom side of moboopen hatches on bottom of PC to gain access.I see 1 huge hatch in our manual, at asus.no 2 laptops are the same unless they are exact model. so learn to find it using below photo.

Did you get any warning at all, or did it just stop for no reason, please? If it shut off while on battery power, what happens when you try to run it off the mains?

Hi Ali. you could try this or go to the link at the bottom and have a read up of what else you could try. Push the computer's F9 button until the Recovery System window appears. Choose the option for Windows Setup and select Recovery. You should see a message disclosing that you will lose all your files in the process as the Recovery puts the machine back to its original factory settings.

How to Restore an Asus Eee PC Netbook ' eBay

www.ebay.co.uk/gds/How-to-Restore-an-Asus-Eee-PC-Netbook-/.../g.html asus eee pc 1000he netbook restore factory settings Google Search

you will have to get his password to get in to alter anything

Then the problem is with the notebook, have it repaired or replace it.

Hello and welcome to FixYa;

It will come on the box the machine was purchased in;

will be on a sticker on the bottom of machine or next to the mouse pad on a sticker (usually on bottom)

but if all else fails;


The machine's s/n is the same as the battery's. Remove your battery from computer and look on there.

Let me know how this worked out for you. If my solution helped you, please rate this solution!
It doesn't cost anything and only takes a second, but it is greatly appreciated.
KittyTech If you need further help, reach me via phone at https://www.6ya.com/expert/carolyn_427ff26936286336

Find every driver you need (including for eeepc 904HD drivers) with this tool driverupdate us. It's free too. Best of luck

Press the Fn-key + V

You can enable/disable wireless by pressing the Fn-key + F2

Are you certain you have the small WiFi switch turned to the ON position? You can usually find the small button on the left or right side of the body of your laptop, just below the monitor.

Download a "password recover program" that will either tell you your password or reset it so you can log in. These are free ware hacker tools so do your research, follow the directions, and most of all, proceed at your own risk.

First thing I would do is pull the battery and the ram chips out. Wait a few seconds then reseat the ram chips and the battery. 9 times out of 10 this will fix your display problem. If it does not than you are looking at a more serious problem such as , motherboard, LCD display or ribbon cable.

1. Suspect dead battery- Your battery might be dead. just replace your battery. 2. Cd-drive spin but cannot run - solutions is - 1. Please check if the support DVD has been damaged 2. Please check if the external optical DVD drive can work normally 3. Please unplug other USB devices 4. Please disable [Boot Booster] in BIOS 4.1 Start the system and press on bootup to show the POST screen. Press again to enter the BIOS setup. 4.2 Set Boot Booster to [Disabled] 4.3 Press to save the configuration and restart Eee PC. Alos with other solutions, ASUSTeK Computer Inc Support Troubleshooting EEE PC 1000HE

http://id.answers.yahoo.com/question/index?qid=20081008045752AAf6YCA

You may need to update the drivers. If the internal device called an Ethernet port is not communicating properly, you may experience that problem. Make certain the cables (Cat5 or6) are inserted well into the Ethernet port of both the computer and the modem/router. To update:>>>

How to reset Asus password if forgot? There is video tutorial:

you need to search for unlocking tools according to your HDD-provider. Each brand has their own tools or just simply a default master password.

try booting in secure mode

Probably needs a new keyboard. They are easy to replace.