GE WHRE5260E Top Load Washer - Page 7 - Answered Questions & Fixed issues
GE washer inlet stripped, cross threaded
If the inlet on your GE washer has been stripped or cross-threaded, it may be necessary to replace the inlet to repair the problem.
To replace the inlet on your GE washer, you will need to follow these steps:
- Disconnect the power to the washer by unplugging it from the wall outlet or turning off the circuit breaker that supplies power to the washer.
- Shut off the water supply to the washer.
- Remove the hoses from the inlet by loosening the hose clamps or fittings that secure them to the inlet.
- Remove the screws or bolts that secure the inlet to the washer.
- Carefully lift the inlet out of the washer and set it aside.
- Install the new inlet by reversing the above steps. Make sure to connect the hoses to the correct fittings on the new inlet.
- Turn the water supply back on and check for any leaks.
- Restore power to the washer by plugging it back into the wall outlet or turning the circuit breaker back on.
- Test the washer to make sure it is filling properly with the new inlet.
Note: These instructions are general guidelines and may vary depending on the specific model of your GE washer. If you are unsure of how to replace the inlet on your washer, it is recommended that you contact a qualified appliance repair technician for assistance.
1/2/2023 8:31:01 AM •
GE Washing...
•
Answered
on Jan 02, 2023
•
198 views
I have a GE washing machine fairly new 2020.door lock went bad replaced it still don't 'work . Ran all the tests and even the door still doesn't lock . What's my problem?
If you have replaced the door lock on your GE washing machine and it is still not working properly, there could be a few different causes for the issue. Here are a few things you can try:
- Make sure the door lock is properly installed and aligned with the latch on the door.
- Check the wiring between the door lock and the control board to make sure all connections are secure and there are no damaged wires.
- Test the door lock with a multimeter to see if it is receiving power and functioning properly.
- If the door lock is receiving power and functioning properly, the issue may be with the control board or another component in the washing machine. In this case, it may be necessary to take the washing machine to a repair shop or contact the manufacturer for further assistance.
It is also a good idea to make sure that the door lock is not being activated by any foreign objects or debris that may be preventing it from functioning properly.
1/1/2023 5:26:37 PM •
GE Washing...
•
Answered
on Jan 01, 2023
•
44 views
Not finding what you are looking for?