20 Most Recent
GE WSXH208A Front Load Washer - Page 7 Questions & Answers
GE WHDRR418 top load washer won't spin at high speed
we can eliminate the motor and the switch since that part is working. sound like your timer might be faulty, timer make everything work in persistence cycles, if its goes bad sometime it tend to jump/skip cycles.
Ge adora washing machine beeps when pushing start with door closed
Hit the power button until there is NO display . Unplug and wait a minimum of 30 seconds , plug back in and within 30 seconds hit SIGNAL button then DELAY START button then SIGNAL button again then DELAY START button again. door should lock and display t01 It is now in test mode . There are 14 different test it can run through in this mode , but all we are trying to do is check for error codes now and maybe get you back to normal, So turn the knob one click clockwise and hit the START/PAUSE button and see if any error codes come up. To exit the diagnostic mode - hit signal button then delay start button then signal button then delay start button and you are out of service test mode and back to normal. Post any error codes.
Water will not drain from washer
I have had this problem before on my GE Arora front loader. Just remove the lower front panel. There if its like mine there should be a cap and you unscrew the cap. It will start to drain the water so make sure that there is something to catch all the water. There is a lot of water. Then after all the water has drained, remove anything that is clogging the drain. Small socks, pens, pocket trash is usually the problem. Then return the cap to the original position and your done.
My ge adora wont pump in water an the wash light does not come on
Remove the lower kick plate on the front of the unit. You will see a "drain boot" going from the tub to the pump. Remove the boot and check for any obstructions in the boot and also while the boot is off, reach into the tub opening to see if there is anything stuck in there.Here is a picture of the boot.
Be sure to have some towels handy as there will be some water in the boot.If that is clear, you will then need to check the door lock assembly to be sure a wire did not come loose and then check it for continuity.Post back your findings to me.
Regards,Richard Rothhttp://appliancecafe.com
How to dissasemble GE model wsxh208a1ww
log on to applianceaid.com/appliance-repair-help. find your make ,model and they will give you step by step instructions on the repair. the site also includes pictures of every detail. good luck ,Steve
Washer would not drian nor spin
no the solution is that the drain pump is dead and needs to be replaced open the front panel of the front loader and locate the filter and clean and also remove!!
WASHER MODEL WCVH6260 LOCK MODE
see this and fix it. God bless youHowever go to instr .manual and read the section troubleshooting if you do not have it download from
www.fitness.manualsonline.com
The processes below will get most controls unlocked.
Duet Washer - Press and hold the END OF CYCLE SIGNAL button for 15 seconds.
Whirlpool Duet Dryer - Press and hold the END OF CYCLE SIGNAL button for 15 seconds.
Kenmore Elite Washer - Press and hold the DRAIN/SPIN button for 15 seconds.
Some Models- Press and hold the control lock button for 15 seconds.
If none of these work try unplugging for 5 minutes
Not finding what you are looking for?