20 Most Recent GE WBSR3140DW Top Load Washer - Page 7 Questions & Answers

It sounds like the springs in your suspension system have gotten weak. You can order part # WH16X544, you should need 4 of them. You can take the front panel off by slipping a putty knife under 2 tabs at the top of the front panel. The top can be removed by removing 2 Phillips screws in the front. Each rod can be replaced one at a time, it would help to have some extra hands to help you. There are tabs at the bottom of each rod that must be popped off while the tub is lifted in order to remove them. Hope this helps

hi, i think

tip washer back to look under will be very heavy so get someone to help there should be two belts check to see if one broke or fell off.

If wash cycle operates and water drains as should before spin indicates motor spinning. Chances are bad timer If your a real fixer you can remove timer control from panel check and clean all contacts internally making sure none are stuck closed . (Have had 3 110s in my time).not easy but can be done or buy new about 150$ reassemble and check operation.

no,its a set level mandated by the epa (environmental protection agency) and the doe (dept of energy) to conserve water and energy it will tell you this in the owners manual

Remove the back panel (or maybe the whole panel) and see if you can adjust the fill in switch. Was it OK. before?

washer will not spin

what is your problem you are experiencing right now okay

washer makes a sqeeling noise where fan belt is attatched but only in one direction.could the machine need rebalancing?

my clothes are soaked after spinning and leaked water in the floor adgitator is loose

google this model ge has lots of transmission issues, check to see if drive spindle is free turning or if it does not let gears turn

what is your model number then we can get started then okay

Please check this link: Bearings

Check the lid switch. See if the magnet is still attached to the lid.