20 Most Recent
Minolta Di3510f Bizhub Copier - Page 6 Questions & Answers
How to fix paper jamb at the heating unit
Since the machine is a production print type machine you may want to have a tech come out as removing the fuser / Fixer (The Heating Unit) can take some doing and the cause of the jamming many.
Error 2558 minolta bizhub
http://www.fixya.com/answer/answerpageslideview.aspx?thid=27174806&ctg=459&brd=1104
Read and attempt the published solution.
Semper Fi
Z
REPLACE DRUM KONIKA MINOLTA 751
Requires removal of the drum and developer unit 2 small screws and the large one in the middle. which holds a locking device. Then remove the charge corona assy. developer unit. Replace the drum with a new cleaning blade. Ensure the Drum Density sensor is cleaned. And Paper Jam senor. As you can see its not easy. recommended a tech. or purchase download service manual.
I Have a Konika Minolta bizhub 211. If I want to photocopy, it will display "caution machine trouble service call COF 32" or supplying tonner. Please what could be the cause of the problem.
Sir/Mam,
Have you had the developer and drum replaced recently, or does the screen say Replace PC Drum? There are certain house chores the copier does before "Ready to Copy" it is waiting for them to get done, so that equals "Please Wait". One big item is making sure the developer and toner are properly mixed inside the image unit underneath the drum or next to it depending on the series. Might want to have the developer replaced and drum/cleaning blade normally done all together, then run the F8 procedure/Developer Charge, and make sure the counters where cleared. Did you recently replace the drum and the developer if so did you clear the counters for the drum and developer, FIRST? IF not then the copier thinks the new drum and new developer are old. The copier works on the counters that is how it knows it got a new drum and developer. Get new developer and a new drum and have it installed correctly. Counters are clear before the unit is yanked out of the machine, then you remove the image unit/drum unit replace the developer/drum and cleaning blade. (DO NOT USE A VACUUM CLEANER WHEN REPLACING THE DEVELOPER static electricity can destroy the sensor located below the developer unit. Then reinstall and RUN F8/Developer Charge. Make sure the fax line and Ethernet cable is removed can't print anything until the F8 is run. Or you will start all over again with new developer and a new drum.
Minolta EP6000 Analogue Copier 210 code clear
Sir/Mam,
Directly below the drum section is assemble called the transfer/separation assy. the purpose of this unit is twofold. (It houses to very thin gold plated wires) One wire is what helps the transfer of the image from the drum to the paper. Since the paper goes between this wire and the drum, the second wire prevents the paper from sticking to the drum during the transfer process. The code you have been getting means either wires might be broken, or has to be cleaned (because of all the toner on it from the drum assy. which needs to be removed and cleaned. Or The end blocks that hold the wires are getting old and allowing the High Voltage that is applied to the wire during the copy/print process to leak to ground. Open and close the front door to clear. If it comes back have a qualified tech look at it.
Not finding what you are looking for?
