20 Most Recent
Kenmore 94702 Front Load Stacked Washer / Dryer - Page 6 Questions & Answers
Kenmore 80 series will spin when draining, but not agitate or spin during spin cycle.
Hello. I'm a little confused at the description of the problem. You indicated it, "will not agitate during wash cycle or spin during the spin cycle." But later in your description you indicated, "It will however, drain and spin after wash cycle and during the rinse cycle." I'm not sure if you description was an error but it sounds like you will need to replace the coupling which is part number 285753A.
Kenmore he2 plus washer will not stay on.
One of your parts was faulty on delivery. Due to the cost of control boards, I would always advice a service call so that you get the correct diagnosis and warranty on the part and the labour if it goes wrong. Unscrupulous dealers will sell parts from scrapped machines that haven't been tested. eBay is the worst culprit.
..
Does a Kenmore Stackable Init have a reset for the washing machine?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
Kenmore elite washing machine with E2f2 error code
The E2F2 error code on a Kenmore Elite washing machine typically indicates a problem with the communication between the control board and the motor control board. This could be caused by a faulty control board, a loose or damaged wire connection, or a problem with the motor control board.
Here are some steps you can take to troubleshoot the issue:
- Unplug the washing machine for a few minutes and then plug it back in to reset the control board.
- Check the wire connections between the control board and the motor control board. Make sure they are secure and free from damage.
- If the wire connections are okay, you may need to replace one or both of the control boards. You can find replacement parts online or through a local appliance repair shop.
- If you are not comfortable working with electrical components, it's best to contact a professional appliance repair technician to diagnose and fix the problem.
I hope this helps!
Washer will not fill with water
Did you check the gauze strainer in the water connector.
To test for voltage, use your multimeter. Turn the machine on and set a cycle, then carefully use the probes to check for voltage.
Kenmore front load washing machine?. What does the L3 code mean please?
Question edited for clarity.
LE, not L3?
LE code on Kenmore washer
An
LE error code is displayed when the
tub fails to spin. The error code indicates that the motor can't operate properly because
you've overloaded the washing machine, or a foreign object is stuck in the tub.
Nov 21, 2022
Not finding what you are looking for?