20 Most Recent
Belkin F5D8236-4 Router - Page 2 Questions & Answers
DHCP Problems
Routers have a built in DHCP server to identify each computer connecting to it so traffic can be routed to the correct computer, if more than 1 computer/device shares the same IP you should get an IP conflict not a DHCP error. Routers also normally give out IP addresses from its pool of IP's sequentially and assigns it to expire in 24 hours, so if you reboot your router turn on 1 device grab an IP and then turn that device off, reboot your router and turn a different device on it will get the same IP, now when you turn the other device back on you have a conflict.If your router has been reset you have to release and renew IP addresses on all your devices to prevent conflicts.
My router does'nt read the modem, it never stop boothing!
Remove ALL cables, verify connections , connect cables, Unplug the Modem, remove battery, unplug the Belkin. Install battery in Modem and plug in, let it run a selftest, when finished, plug in Belkin allow it to selftest. Reboot computers.
How to reset password
At bak of the router or underneath of the router there must be a reset , press it and hold it for 30 sec the release. power cycle the router.
How do you reset belkin wireless rounter
On the router you will find a small reset button. Press it and hold it down for 30 seconds. You may need a pen or a paper clip. Release the reset after 30 seconds. wait for 1 minute till the power light becomes solid. unplug the power and plug it back in. wait for 1 minute again.
Now once you reset the router, it will loose all the settings. You will need to reconfigure the router.
Click here for step by step instructions
I'm trying to figure out
The routers can come with a pw on them from the factory but unlikely in most cases. To get the pw from a router is easy unless somebody changed the login information. On a pc that is connected to the network enter into the address bar of you browser 192.168.2.1 this will take you the router login page. The login requires no password just click login. Under the wireless section select security the key should be shown here. If the is blanked or stars you can just create a new one at this point.
The wireless light will not come on belkin router
Try pulling the power cable for 15 seconds on the modem, then plug it back up and then wait for all of the lights to come back on. Then pull the power cable on the router for 15 seconds, plug it back up. Also you have a reset switch on the back of the router that may help if the power cycling doesn't work. Hope this helps fix your problem-good luck...
Help me with my wep key please
Reset your router back to it's factory settings by holding the reset button for about 5 seconds. I have provided a list of the most popular router brands. If it does not work you may need to google what your specific model's default IP address/default username/default passwords are, for example search for "Encore ENHWI-2AN3 default IP address" The default login info can change, it can depend on where you obtained your router. If you purchased it yourself from a store then the standard defaults should work. If you obtained your router from your Internet Provider you may need to contact your service provider. It also may depend whether it's an old or new model router as well. And you may need to press and hold the reset button on your router several times before it actually clears. Make sure you have a wired connection then once you have accessed your router simply run the Setup Wizard. Set your SSID as something you'll remember like "Mavericks Network" and your Password can be something like your phone number for example 3109876543
Belkin - Username: Leave the field blank Password: Leave the field blank Default IP address is: 192.168.2.1
Buffalo - Username: root Password: Leave the field blank Default IP address is: 192.168.11.1
D-Link - Username: admin Password: Leave the field blank Default IP address is: 192.168.0.1
Encore - Username: admin Password: admin Default IP address 192.168.1.1
Linksys - Username: admin Password: admin Default IP address 192.168.1.1
NetGear - Username: admin Password: password Default IP address will be: 192.168.0.1 or 192.168.1.1
TP-Link - Username: admin Password: admin Default IP address 192.168.1.1
TrendNet - Username: admin Password: admin Default IP address 192.168.10.1
Zhone - Username: admin Password: admin Default IP address 192.168.1.1
Zyxel - Username: admin Password: 1234 Default IP address 192.168.10.1
Not finding what you are looking for?