20 Most Recent 3Com Baseline Plus 2226 24Port Ethernet Switch (3C16475CS) - Page 5 Questions & Answers

my facebook was blocked by 3Com. How to unblocked?
the error is coming out is.

You have tried to access a site that has been blocked by the 3Com Router.

Please contact your System Administrator to have this site authorized

please help me on this problems.

SHIVA

Solution ... say the answer helped.

You're rts/cmos battery has died. You need to have it replaced or this will keep on happening.

What I was told through the mfg. was:
pins 1,8 =NC
pins 2,7= Chassis Ground
Pin 3= TX-
Pin 4= TX+
Pin 5= RX-
Pin 6= RX+

This would actually be a RJ45 (8pin) but uses the 6 pin cable and only 4 com wires.
Evidentally there is no standard for the pin usages for serial communications with RJ connectors. So this information might not be valid for other equipment.

"Forgot email" option, you will have to answer security questions.

You didn't give a model number, so here is a manual for a 3 Com Baseline switch.http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02581571/c02581571.pdf

Google model number for manual,but no driver for such devices needed to work out

Please check the connections and the settings. Check on the cables, teh connecting links. Refer to the manual for the settings required. Also check with the provider for the default settings.

Hi

You do not say which operating system you use.

Press and hold the Router's Reset Button (sometimes you need a pen to push a Press Plate) at the rear of the Router.

This can be used to Restore the Router to Factory Settings, set the Router back to Default Username and Password (2-5 seconds) or, sometimes, clear the Username and Password for you to enter new ones (usually15-20 seconds), depending on how long you Press and Hold the Reset Button.

Alternatively:

Windows XP
Start > Run >ipconfig.exe > Enter, will reveal the IP Address of the router.

Windows Vista:
Start > type "command" in search box at bottom of Start Menu > click "Command Prompt" at top of Start Menu > type "ipconfig" after the C: \>

Windows 7:
Start > type "cmd" in the search box at bottom of Start Menu > click "cmd" at top of Start Menu > type "ipconfig" after the C:\>

Log onto the internet and type in the IP Address in your browser window and press enter. Access the Router Setup and follow the steps to configure it.

I hope this helps. If this Answer goes some way towards helping to resolve your Query, Problem or Fault, please take the time to Rate it. This helps Answerers, like me, better understand the needs and the point of view of Askers, like you, and guides us in exploring the best ways to provide the most useful, highest quality Responses we can. If you need further help, please do not hesitate to post another Question or add a Comment to this Question. Thanks for using FixYa.