20 Most Recent Kyocera Mita FS-1920 Laser Printer - Page 6 Questions & Answers

The optimizing performace may be because of the temperature in the room.Clean out all filters in the machine.Do not reset the drum light unless you do change the drum as the copy quality may degrade.

Firmware is not available on line! That is property of the company they only give out o authorized dealerships and corp techs, you will need a tech to re-flash the firmware. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

IF SOME KEYS NOT WORKING THAT MEAN YOU HAVE TO BLOW THE KEYS FIRST . MAY BE SOME KEYS ARE STUCK . IF THAT DOES NOT WORK I AM AFRAIED YOU HAVE TO OPEN THE KEYS PANNEL MAYBE ONE PRESS ELEMENT OR MORE ARE DAMEGED.IF SO YOU HAVE TO REPLACE IT.

1087 TWICE

IF YOU MEAN THESYSTEM MENUE PRESS 1087 TWICE.

http://www.manualslib.com/manual/288946/Kyocera-Km-2050.html?page=65 or https://www.manualowl.com/m/Kyocera/KM-2050/Manual/166911

Hi You need to check that the paper detection sensor just close to the rollers is still there , you might have blown it out of place or worse broke it , that's the only sensor that detects the paper

Not possible

You can try resetting the fuser error code by performing the procedure below: On the copier type - 10871087 (may have to be in the job status menu first) Once in MA mode type in - 163 Start Execute Start You should then either cycle the power or the machine will cycle for you. If this does not work you will need a new cleaning lamp for your fusing unit.

If you go to kmaconnect and read, there is a fix for that problem.

The cleaning lamp (which is in the drum unit) is defective. Replace the drum unit.

First you have to check the counters to see how many pages were printed or copyed. It may be a problem with some of the color drum units. At this model you need to change the units near to 100.000 A4 prints with 5% coverage. If the coverage is greater, then you'll need to change them sooner. There might be another cause for the sound, like the Transfer Belt Unit. This unit has a "waste toner path" that might be jamed. The unit is not able to get rid of this waste toner and some gears produce that noise. The transfer belt unit is working separatly for black prints and color print. You will have to remove the Transfer Belt Unit and clean the toner path with a vaccum cleaner.

You will need to replace the cleaning lamp for the drum unit or replace the engine board

Defective Charging Unit .. Cause of black copies.

press10871087 after press 163 reast

press 10871087 after selct 130

my dear you see dim ram and clean

Hi Not being an engineer, I can't be specific about your problem, but you can get a full service manual for your machine relatively cheaply here: Kyocera Mita KM2560 Service manual Parts Repair manual download A description of the contents is given on this page and I also give it below: "Service manual in English: maintenance, repair, troubleshooting, error codes, service mode, adjustment Parts catalog: parts list, parts numbers, exploded diagrams Service bulletin: Supplement manual, updates Firmware" Hope this is helpful, if so would you please register that with Fixya Cheers

This problem can be caused by many reasons :- 1) Drum unit malfunctioning. 2) Developer unit malfunctioning. 3) Drum unit not getting proper electrical contacts located on the backside of the machine.