20 Most Recent Kyocera Mita FS-1920 Laser Printer - Page 9 Questions & Answers

It's most likely a hard disk error. Try getting the HDD replaced.

you need to reset the fixing unit. go to mode and input 163 then start off then on.

Ho Renee, i Will Send You Video please watch this video and fix your error In Case You Still face Problem and Need Online Assistance Then Please Follow Us For On : Konica Printer Support

This is a hard drive failure go into the service mode and run u906 to try and reset it if it fails to reset you wil need to replace the hdrive

your du-61 duplex unit is faulty or not installed correctly check the harness and gates if all this is ok its the engine pwb has failed

sounds like the scanner is still locked so it dosnt scan the image giving u blank copies or black copies

my dear your problem in grid wire or mother board

my dear you clean grid wire