20 Most Recent Kyocera Mita KYOCERA/MITA - KM-C3130 Printer - Page 8 Questions & Answers

What error code are you getting? It could be a lot of reason for paper to get stuck, there is always a error code associated with each jam

A limited connection on a Windows PC usually means that there is no connection to the internet on that segment. That is if you connect to the printer via a network switch or LAN. Newer printers can act as a DHCP server/router assigning IP addresses to LAN clients. It has no impact on your LAN if you do not want or need a connection to the internet. However if you want to access the internet from this PC I suggest you get a separate router and use that as the DHCP server on your LAN. Connect the PC and the printer to the router and disable the DHCP server on the printer. Also make sure that all devices (PCs and printer) are using the router as the default gateway. Once again if you don't need an internet connection the limited connection shouldn't worry you.

try to reinstall the printer driver

Please can you be more specific?

This error code is related to the fuser unit and should be investigated by a technician.

This indicates that you may have a problem with the Dimm or the main board.A technician may be required to correct the problem

This can be caused by a number of reasons.Ensure that your paper is not damp.Ensure that you do not have toner save/eco mode turned on.The optics may be covered in dust.The transfer belt unit may not be lifting/locked into place correctly. Are you using genuine toner? if not try using genuine toner. Will take hundreds of copies before the quality improves.The list is extensive that may cause this problem.

Please can you tell me the model?

This is a fuser unit error and will need to be addressed by a technician.

Please can you state the model?

Check that you do not have any paper jammed behind the cassette first.Usually it is the lift motor itself that has failed.If you can let me know the model I can assist you further.

Please can you be more specific as I am unable to understand the problem that you are experiencing. If the copies have background but the prints are ok then try adjusting the exposure settings on the display panel

If this only occurs when using the document feeder then you will need to clean the smaller glass that sits next to the large glass that you manualy place your documents. The document feeder scans the originals over the small glass and any ink ,whiteout that may be on the glass will appear as lines down the pages

Please can you tell me the model number

Please can you tell me the model number?

This needs to be done by a technician as you can easily damage the drum!