Kyocera Mita KM-2550 All-In-One Laser Printer - Answered Questions & Fixed issues

Question edited for FULL, 'make model (what it is)'. Question moved to correct category. This page in the manual refers. https://www.manualslib.com/manual/1214948/Kyocera-Taskalfa-2550ci.html?page=189 ..

Question edited for full 'make model (what it is)'. Question moved to Kyocera. Try a power reset. Remove cassettes. Pull mains plug for 2 full minutes. Reconnect. You should get a 'No Cassettes' message. Insert cassettes. If that doesn't work, you will need Kyocera Service for this business machine. Some ideas in the link. https://www.google.com/search?q=km+2560+not+detecting+cassettes ..

turn off machine unplug network cable turn it back on if it works your print job is the cause delete t

Clean the slit glass or open the glass and clean the mirrors from the dust. I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

this - two- reasons 1- the corrona on the top of drum unit is very dirty or its connection point are dirty with toner . just clean it then replace it again .if that not help you ll need to chick the corrona board

Related to the power supply or power supply pcb

Not enough info. Do you not have a cable? USB perhaps?

Replace the springs in registration sensor.

This code is a defective developer or main PCB. I would try changing the developer first being that it is significantly cheaper.

http://usa.kyoceradocumentsolutions.com/americas/jsp/Kyocera/resource_details.jsp?rid=14162

Print Mode Error is Chenglish for a problem with printing. Press the Print key at the left side of the panel, then the display should tell you to add paper etc

Switch on your bonjour in the printer settings

install proper print drivers. Install the KX version 6 drivers

You need the proper print drivers. Download the drivers and update or re-install your drivers

Try loading paper in the bypass on the left hand side of the machine.It may be that you are trying to print a document that is a different size to the paper that you have loaded in the copier.

program 10871087 after you selct 906 reset

my dear bro you selct 2by2 doplex

Defective DP main PWB. Device damage of EEPROM. not so good fault this one - if you are an engineer prepare for the main PWB replacement and calibration that follow ( you could try as a last resort re-writing the firmware/ replacing the eeprom chip and re-writing) if you are a customer- suggest you upgrade your printer to something else as it will be the cheaper option. Sorry for the bad news

chek your power 110 or 220 220 ok and 10871087 163 exicutive restart prblm not slvd?? thn chek fuser lamp nd thermistr fuse

mechine of and on... that time adf littile soud for gears? then ok ....not sound o=chek adf board and conections