Top 20
Kyocera Mita KM-5035 Printer - Page 7 Questions & Answers
Error c7400
Developing unit connector insertion
problem
Absence of the developing unit is
detected.
Developing unit
connector inserted
incorrectly.
Reinsert the developing unit connector if
necessary.
Defective developing
unit connector.
Replace the developing unit.
My copier does not fix copies and lamp is not coming on
Hi George, that is weird because the machine should error out a c60xx. If the fuser unit is cold without error code i'd go for a bad board.
In case the fuser is hot, you should check the pressure roller/springs.
I hope this helps
peter
Km 2820
What error code are you getting? It could be a lot of reason for paper to get stuck, there is always a error code associated with each jam
Clearing codes
This is a hard drive failure go into the service mode and run u906 to try and reset it if it fails to reset you wil need to replace the hdrive
Limited Connection Error
A limited connection on a Windows PC usually means that there is no connection to the internet on that segment. That is if you connect to the printer via a network switch or LAN. Newer printers can act as a DHCP server/router assigning IP addresses to LAN clients. It has no impact on your LAN if you do not want or need a connection to the internet. However if you want to access the internet from this PC I suggest you get a separate router and use that as the DHCP server on your LAN. Connect the PC and the printer to the router and disable the DHCP server on the printer. Also make sure that all devices (PCs and printer) are using the router as the default gateway. Once again if you don't need an internet connection the limited connection shouldn't worry you.
Black lines on copy only when printing but copying
If this only occurs when using the document feeder then you will need to clean the smaller glass that sits next to the large glass that you manualy place your documents. The document feeder scans the originals over the small glass and any ink ,whiteout that may be on the glass will appear as lines down the pages
How to repair j40 problem in km-1500
J40 means that you have a paper jam located in the fuser unit of the machine (the hot part)You will need to locate and remove the jammed paper.Faulty fuser sensor.This may need to be looked at by a technician.
C3200 error
if it is MFP then try cleaning copy lamp if problem not solved replace it. There is a chance of scanning cable defective.
3530 manual
Please can you be more specific as I am unable to understand the problem that you are experiencing. If the copies have background but the prints are ok then try adjusting the exposure settings on the display panel
C710 error
Please can you tell me the model number?
Km2050 c0210
Main board and engine board not communicating.Try switching off at the wall for 30 minutes.
Kyocera 5050
Please can you provide more information on the quality issue.too light,too dark?
Not finding what you are looking for?