https://www.youtube.com/watch?v=a2FCo3JTO00
E02 error code: control board or motor issue. Test the motor first to check if the motor can runing normally. If motor is normal, replace the control board. E03 error code: 1,Turn on the treadmill , motor running a few seconds then stop and console board shows E03, probably the Speed sensor issue.
https://anytreadmillparts.com/pages/treadmill-error-code-troubleshooting
Hi sir
Hope you are well
This is indicative from EPROM faulty memory.
The firmware is corrupt, you must replace the complete
console control is the computer or CPU or microProcessor.
Call to the company to see if possible to get the version or EPRO only¿
Blessing
[email protected]
cell+whatsApp: +50588611441
Measure the voltage at the terminal of Main Motor for DC, between 0-120Vdc. if there are NOT, the Controller Board Motor is Faulty. Replace it.
this Board has 3 power supply: 1) Console Board 2) Elevation Motor 3) Main Motor. Some IGTBs are defective.
Blessing.
[email protected]
cell+whatsAPP:+50588611441
LED Blink Patterns on the Control Board Treadmill