Dayco 5061015 Serpentine Belt - Answered Questions & Fixed issues

New Holland Ts90 Ts100 Ts110 Tractors Service Manual

2008 Saturn Outlook, 3.6 liter. Tensioner pulley outline and diagram for serpentine belt placement.

Get this from BMW or a parts supplier.

-Possibly one of the idler and puller is not line up. Or betl is too loose. Good luck Mai

Release the tensioner ,make sure you have a diagram written of the way the belt run and check idler pullies for noisy bearings , slide old belt off and new one on release tensioner.

By law there is a decal under the hood which shows this. If removed or damaged, check your local library for repair manual (free) or try google search for answer. Or just look at this: http://www.dieseltruckresource.com/dev/6-7-belt-routing-diagram-t291826.html

hope this helps.

I had a similar issue in my 2001 grand am. Turned out the power steering pump pulley was not properly seated on the shaft, causing the pulley to be slightly out of line of the other pulleys. It was hard for me to see it, that's how miniscule it was. Bottom line is I would do a thorough check of all the pulleys in the serpentine line first for any visible damage. If all seems ok on that front, I'd take the vehicle to a repair shop to make sure all of the pulleys are in alignment. If one, for example the power steering pump pulley is out of line, not only will it continue to tear up belts, but could potentially damage the power steering pump as well. Hope this helps!

Under the hood on a lot of models is a paper with the belt routing, if this is no longer there your local ibrary normally has a good selection of repair manuals on hand.

your want the to know more about the 2000 land rover

Here is the drawing:

What Year, make, model, engine? If you need further help, I’m available over the phone at https://www.6ya.com/expert/justin_3ae27a9d61d6acd4

There should be a digram under the hood, on the bracket near the radiator, or on the under side of the hood it self showing the route of direction for replacement. You will also need a special tool you can rent from Auto Zone to loosen the tensioner.

There should be a small nut in the center of the tensioner and you need a Special Tool to get to it. You can rent the tool at your nearest Auto Zone or other part store and that should solve your problem.

If you call the parts house where you purchased the belt they can provide you with a routing diagram for your vehicle based on make model year engine and options. My local parts house is very helpful and will fax or email it nearly immediately. I think this is normal good service

1. Take the car to jiffy lube!

Hi there:Check this information for...Model TAURUSEngine V6 3.0L 182ci GAS FI N UHope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.

It sounds to me like one of the belt-driven accessories is stopping. Remove the belt and turn all of the accessory pulleys by hand, both slowly and quickly, in both directions. Any that does not turn smoothly, quietly and easily is suspect and that accessory should either be replaced entirely or have its bearings replaced (if practical). In my experience, the most common accessory to cause this problem is the power steering pump, but it could be any of them.

I am showing this is the diagram for 2001 6.6L 3500, Hope it helps