Top 20
Ricoh Aficio 2015 Copier Questions & Answers
1600l sc code how to reset
press the orange key for say three times and press 107 and then press and hold the clear key for about three to four seconds .
the machine zill take you to the sp mode.
turn off the machine and put on again after a minute.
good luck
I have a ricoh aficio 2035 and there is error code sc 350, what can i do ?
SC 350 relates to problem of ID or image density sensor, first of all clean it with IP and check if problem persists go to SP mode and check in input check under modes,replace sensor if found defective,if problem resolves but recurs again check for toner flying and developer and drum life, chances of sensor failure are very less.
Sc901 at 2015
The mechanical total counter is disconnected.Possible Causes• User removed the counter while it was operating• Poor connection• Mechanical total counter defective
Scanner not working
describe problem in more details about what technic u are using to scan , desktop binder or scan to email?
Error sc542 RICOH AFICIO SP3510dn
1. Mode(Yellow Button)
2. 107
3. Press STOP Button for 3 second (RED Button)
4. Copy Sp
5. 5810#
6. Excute
7. Power Off
8. Power On
Replace cleaning web
Maybe you meant photoconductor there is no web in copier. Or you got wrong model of copier
Sc 101 sc101
Exposure lamp error.Verify the exposure lamp and the expo lamp thermistor.
Missing print
machine needs drum and developer, but a temporary fix would be...open front door near notice green handle where toner is replaced, look to the right of green handle and down about 2 or 3 inches, you should see a plastic or chrome cover the size of a postage stamp, remove the cover and you should see a 3/4 inch wide piece of glass barely sticking out, carefully grasp the glass and pull it out of machine, wipe the toner off the glass , put glass back in and replace cover , shut front cover and run copies .
Sc fusing error dsm615
you can try to reset the code by entering into service mode, just enter into service mode and then shut down the machine by the main switch and then turn it on after 30 seconds.
For to enter into service mode press the following keys in the next order:
press the yellow key ; then press 1-0-7 and then press the red key and hold it pressed until on the screen do not show service mode.
If after this again the machine gives fusing error, it means that you have problem some part in the fusing unit. possible is the termistors or the teromstats
After replacing the main motor of my richo afico
Yes, If you have installed a main motor from Aficio 1015 the machine will work and there will be no SC Code displayed, but the machine will print a reduced image.
The part number for the main motor for Aficio 2015 is :
" AX06 0270 Brushless Motor 24V/20W "
Error 541
replace thermistor &enter sp program &turn m/c off and on
Not finding what you are looking for?