20 Most Recent Ricoh Aficio 1035 Copier - Page 6 Questions & Answers

connect your copier to a switch or router.

Goto user tools/counter. Select interface settings. Enter the IP address of the copier, enter the gateway address to the router. Press file transfer. Turn the deliver server on. It will take a few seconds but it should populate the IP address to the computer that desktop binder is installed to and insert the users assigned to the scanner program.

bagai mana cara meriset error 240

LD unit, or BICU board....Do LD pitch adjustment -both 400 and 600dpi

Possible Causes • High voltage supply board defective• Poor connection at the developmentbias terminal• Poor connection at the high voltagesupply board

SC545 and SC 546 are fuser temperatyre error. pls. check thetmistor/ thermostats, connectors if thernistor are deffective replace thermistors. after replacement or checking of this parts do the SC reset. 107 # turn off copier then on after 5 sec.

THE CHARGE ROLLER IS LEAKING BECAUSE THE DRUM ONE SIDE COATING IS DAMAGED. THE CHARGE VOLTAGE IS DIRECTLY GOING TO ALUMINIUM SURFACE. SO COVER THAT PART OF CHARGE ROLLER WITH A CELLO TAPE THE ERROR WILL NOT COME.

sounds like the power supply board blew up

Error code 990 indicates software problems yuo can check in SP7-403 for information.
Error code 540 will proberly indicate some heating trouble in the fix, you have to reset the machine with service code SP5-810.
Code 350 will disappear if you restart the copier.

No


Thew problem is software performance error
The software makes an unexpected operation.
•Defective software
•Defective controller
•Software error

Do this:
1.Turn the main switch off and on.
2.Reinstall the controller and/or engine main firmware.

paper jam in aficio hasnt reset . but you must check all doors .it may be one door in your machin is open .more than more right door check it

Ld unit problem. This code can be very frustrating, as it can be triggered by several things -top right door switches shorting out, toner on the LD unit board, laser synch board problem, bad connection between the BICU and the LD unit, etc.
The bottom line is, if you're not a technician, you will need one to solve this error.
Make sure to always perform the LD pitch adjustment (both 400 and 600dpi) after doing any service to the laser unit.

first you check pm life of drum kit if finished than replace it second clean laser unit (ld) you will discover that this code will never shows again.

Try this !
Press yellow "c" buton, type 107 and then press and hold the orange "c" button for 3 seconds.
You will hear a "bip" and the machine should enter the SP mode.
Now just turn off the main power switch located on the left side of the machine. Turn it on again and see if the error appears again.