20 Most Recent
Ricoh FT5832 Copier - Page 2 Questions & Answers
FUNCTIONAL PROBLEM, SC544
A fusing temperature of over 250 °C is detected 5 times by the main control
board (this takes 5 seconds)
- Possible Causes -
· AC drive board defective (check the triac)
· Fusing thermistor defective
· Main control board defective
For safety reasons, Level A service calls cannot be cleared by
turning the main switch off/on. The following procedure must be
performed to clear these service call conditions after servicing
the machine.
1. Turn on the main switch.
2. Enter SP5-810 (SC code reset) and press the Enter key.
3. Exit SP mode and turn the main switch off and on.
Ricoh MP 2510
Fuser installation error. Fusing unit set error. Remove the fusing unit out of the machine and reinsert it. It isn't seated in there properly. Once you do that the error code will go away.
Error code 440
heavy load on main motor check that wires and thin built s not cut
Error code E70 on ricoh FT 4418
Empty the waste toner tank.
1. Open the front cover
2. Lower the transport unit
3. Pinch the cleaning blade release lever and slide the cleaning unit out.
4. Remove the 4 screws in the top cover of the unit.
5. Dump out the waste toner.
My ricoh FT4418 wont copy
It means the toner overflow sensor was tripped: http://www.copier-help.com/copier-help/ecs/ricoh/ecrft4418.html
We have a Lanier Copier
yes it does. the hard drive is located on the left side in back of the machine, It is easy to remove. If you are trading it out, you can either remove it yourself or have a service rep remove it.
I have done that several times for customers who do not or can not allow hard drives to leave their presence.
Won't copy shows blank page
i would be looking to see if the developer unit is locked into place also look to see if the scanner lamp is coming on
Sign E is shown.
look my friend e means that error code press on numbers ./* in circle then revealed number like e-101 that examble
Not finding what you are looking for?