Top 20
Ricoh Aficio 450 Copier Questions & Answers
HOW DO I REPAIR ERROR CODE 819 WITH A RICOH AFICIO 4500 COPIER
This IS a fatal kernal error, of the controller, the ONLY hope without changing the controller/hard drive, is to power down unplug copier,( I turn power back on with it unplugged) this bleeds off power in the caps. I have had this issue 3 times this year. -Carl
Aficio error sc329
I AM SURE THE ENTIRE MEMORY HAS BEEN FORMATTED.
PLEASE ENTER SP MODE AND ENTER SP 21039 AND 21094
AND THIS ERROR WILL NOT APPEAR AGAIN.
Sc335 ricoh model 2075
need more information as to what the problem actually is or error message you are getting before anyone can help you with this
Touch screen blocked
The touch screen could have lost its calibration, but there is a good chance that it is bad, and needs to be replaced. To calibrate it, push the yellow clear modes key, then the numbers 1, 9, 9, 3, then push the red "Clear / Stop" key 5 times, and choose number one. Follow the prompts. Use a stylus or other dull pointed item. If you don't get a response, you need a new touch screen.
Reset code ?
Hi
1. Press the Clear Mode key.
2. Use the keypad to enter "107".
3. Hold down Clear/Stop for at least 3 seconds.
4. Enter the Service Mode.
Hold down # and then press Copy SP
this is special sp mode...
then enter 5801 and then press #.....> Now press execute after seconds press ok and turn off and turn ON your device.
Ricoh aficio 4850 emf
Most fuser problems have to do with the fuser lamp and or the thermistor, or the thermal fuse. If you can put you hand near, and I did say near, because the fuser is very hot and can burn you, you should feel heat. Use an inferred thermometer to pick up heat. Should be around 225 degrees F +- a few degrees. If no heat detected the lamp is bad or is not receiving voltage. The thermistor detects heat from the fuser roller, it lays on it, and sends a signal to the logic to turn up the voltage to the lamp or turn it down. The thermal fuse could be open hence not voltage to the lamp. Last but not least no power from power supply or no signal from logic board to turn up the juice. Hope that helps.
WHAT IS HDD
Hard Disk Drive - identical to the one in your computer (but probably a different size). It is where the images are stored when making copies. If you have a failure, then it is probably reporting that it cannot read or write to the hard disk.
Sc732
It could be that the shifting roller that shifts paper from side to side in the almost top area of your finisher has its movement blocked, or that there is a defect in its motor. This roller lies below the flat black paper guide that leads paper out onto the finisher's shift tray.
Asking input user code
Copier has been setup to use code. Will need to turn feature off if you don't want to it. Look in your manual or go to ricoh-usa.com/download enter model in search box click on manual
Mp 4500 sc 450
Fuser Unit error.
Confirm the Thermistor,Thermostate,Heater Lamp
Execute SP ,go to 5.Mode and 810 and START BUTTON.
Not finding what you are looking for?