Top 20
Mitsubishi WD-52525 52" Rear Projection HDTV Questions & Answers
52 inch Hitachi rear projection HDTV. No picture. Just vertical colored lines.
If you wish to get some details; visit the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
Line faults & possible causes to LCD & Plasma screen are given with illustrations
. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.
Search the site by type in the "BRAND NAME" of your device; (
Exclude the model number), in the "
Search box at the top right of the display window of the Homepage" to get gathered related posts
4/15/2017 8:09:03 PM •
Mitsubishi...
•
355 views • 0 helpful votes
Repair dead pixels?
Dead pixels can not be repaired.
The model# WD-52525 you provided is for a DLP TV.
If you are seeing white dots on the screen it is due to a bad DMD chip or light engine. Unfortunately, it is not a cheap fix.
Good luck
www.aaatvservice.com
8/10/2014 8:15:03 PM •
Mitsubishi...
•
211 views • 0 helpful votes
1999 toshiba CZ36T1 blacks out for hours then comes back on.
Hi Terrence
Probably bad connections in the lamp base.
Heat damaged or corroded or Over temperature sensor tripped.
When it goes out next, Bump it or Tap it to see if its mechanical contact problem. That will help diagnose where the problem is
Good Luck
5/20/2014 3:40:55 AM •
Mitsubishi...
•
43 views • 0 helpful votes
I have a Mitsubishi WD52631 that seems to have intermittent problems turning on
Ballasts were sometimes problems with this set, but I also ran into problems with lamp thermal sensor. It's a small rectangular device sort of cream color and about 1/8th X 3/16th X 3/4 inch in size with lead coming out of one end. Also check safety interlock switch, which is actuated by lamp access cover being properly closed.
1/1/2014 9:09:47 PM •
Mitsubishi...
•
113 views • 0 helpful votes
Dlp blue screen
the lamp eng it bad you need to replace the dmd or the hole thing the eng, whear the lamp in stall at and i done a lot of them to and that cost a lot 1000.00 plus the core you need to send back to mitsubishi you may whant to call them to see if it under wearenty if not that will till you how much it cost to have it replace..it a big job it chang them to about 2hours to replace them the lamp eng ..good luck i hope this help you out...me my self don,t like a dlp at all the lamp cost to much to replace for lasting just a year. lamp should last about 2 years but i not seen a lamp last that long at all..the samsung is just as bad... will good luck
11/19/2013 6:49:14 PM •
Mitsubishi...
•
91 views • 0 helpful votes
Power light keeps blinking
try pressing the small reset button on the TV the light should blink rapidly for about a minute and then stop if it does not stop you will need to have the TV repaired
11/4/2013 3:08:14 PM •
Mitsubishi...
•
55 views • 1 helpful votes
Not finding what you are looking for?