Mitsubishi WS-65513 65" Rear Projection HDTV - Answered Questions & Fixed issues


Your going to need to measure the various power supply voltages to see if its a bad main or power supply board

Mitsubishi... | Answered on Nov 08, 2017 | 446 views


If you have the time you might just want to measure them with a cap tester. It is not uncommon for a bad capacitor to look beautifully new.

Mitsubishi... | Answered on Aug 26, 2017 | 48 views


Misaligned pin cushion adjustment, of damaged component/s at this stage circuit inside. Contact any service technician. If you wish to get some details; visit the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/

Mitsubishi... | Answered on Jun 05, 2017 | 37 views


Take it of letterbox and put it on full ratios

Mitsubishi... | Answered on Mar 03, 2017 | 296 views


resolder the 9 vol;t regulator Ic right behind the input board in the back

Mitsubishi... | Answered on May 05, 2015 | 161 views


If you have to change one or two bulging capacitors, then you may as well change them all. They won't cost much and would be available in any electronics store. Just make sure the values in uF as WELL as the voltage and temperature ratings are the same. All the info is stamped on the capacitors jackets.

Mitsubishi... | Answered on Nov 17, 2013 | 42 views


I also have the blinking green light problem with my WS-65513 Mitsubishi TV. I would appreciate any information you could send to help fix this problem. Thank you, Keith. elitemachine @netnitco.net

Mitsubishi... | Answered on Oct 03, 2013 | 224 views


A quick fix for this is to use a hair dryer to heat up the capacitors and then plug the tv back in.  It should only take about 90-120 seconds to heat them up depending on how hot the dryer is.  The cap's are located on the right side.  Take the front cover off the TV, and heat up the box that is about the size of a small cable box on the right side.  Once the cap's are warm, they will stay warm as long as the TV stays plugged in.
Scott out

Mitsubishi... | Answered on Jul 10, 2013 | 1,716 views


what is the answer to my question please!!!!!!!!

Mitsubishi... | Answered on Apr 10, 2013 | 31 views


by using a computer with proper connector

Mitsubishi... | Answered on Mar 11, 2013 | 16 views


First disconnect the front keyboard which has the reset switch--the switch can fail and cause this exact issue.

Mitsubishi... | Answered on Dec 22, 2012 | 52 views


check all inputs and see also if it does it with a DVD hooked to a rear input-----Important: the picture does this or not when the menu is called up-----if menu ok in this respect that will narrow where the problem is..

Mitsubishi... | Answered on Dec 08, 2012 | 29 views


if the lamp indicator is blinking,you will need to replace the lamp.

Mitsubishi... | Answered on Sep 21, 2012 | 15 views


The real question if model number indicated here is correct is does the green power light on the set come on at all ?

Mitsubishi... | Answered on Aug 30, 2012 | 65 views


Hit the pic adjust button until you get the picture you want. If it does not change correctly, then you need to change it on the Sat box.

Mitsubishi... | Answered on Jun 20, 2012 | 88 views


Check in the sets menu for closed captions and find TEXT.

The feature was never really used but a lot of sets have it=====a few cable or sat boxes also have this feature.

Turn it to off.


let me know if you have questions.

REGARDS, SD TECH

Mitsubishi... | Answered on Sep 17, 2011 | 50 views


In doing some electronic testing in your tv you should be familiar with the parts specially the convergence section of your tv but if you are not handy in electronics I suggest that you should contact a service technician because one mistake your tv may not be repair or it will be harder to repair. And it will save you from stress good day and best regards.

Mitsubishi... | Answered on Aug 19, 2011 | 23 views


You have to pull the speaker cover off, and disconnect the connectors going to the OSD board, the contrlo board, and remove the scwers at the bottom of the fram and then it will take two people to lift and puul out at the same time, to remove the screen.

Mitsubishi... | Answered on Aug 10, 2011 | 28 views


dc6piece,

This unit does not have a HD tuner so you would need a separate box. See Best Buy. They can help you.

Thanks for using FixYa and for the great rating.

hardrocko

Mitsubishi... | Answered on Jul 15, 2011 | 42 views


Make sure its not your input source. See if you get the waves through both a DVD player and a Cable box. If you do, your signal board is bad.

Mitsubishi... | Answered on Jun 16, 2011 | 131 views

Not finding what you are looking for?
Mitsubishi WS-65513 65" Rear Projection HDTV Logo

295 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1257 Answers

The Knight
The Knight

Level 3 Expert

76204 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...