20 Most Recent Whirlpool WTW6500W Washer - Page 3 Questions & Answers

Check to make sure the front controls are plugged in to the control board. Otherwise, replace top control interface. Not cheap.

Whirlpool... | Answered on Nov 10, 2019

Could it be SD which is on the link below
If it is the problem could be to much or not the right type washing detergent.
When it keeps filling it could be trying to drain and add water at the same time to remove some detergent.
Videos below


Whirlpool... | Answered on Nov 10, 2019

We are FIXYA dot com, we aren't Whirlpool. As long as you can ascertain that there is power at the unit, the most likely part to fail is the main control board due to condensation, especially if you were away in winter.

Whirlpool... | Answered on Nov 10, 2019

Your Cabrio is continuing to fill (Long Fill) past the set limit, causing a Flooding potential.

Whirlpool... | Answered on Nov 04, 2019

My LG washers tub became loose and when I took it apart the spider arm on the tub was corroded and broken this holds the tub straight and it is mounted on spring for vibration. The tub was damaged but repairable and I installed a new tub seal

Whirlpool... | Answered on Nov 03, 2019

If it started suddenly it could be something worked loose, broke or got jammed between the drum and tub. If it has developed over time it is probably the main bearing.
Link below might be helpful...


Whirlpool... | Answered on Oct 28, 2019

Continuity means there is a connection. A short is an unregulated connection. It's likely the motor has shorted out most of its field coils, and that's blowing out your CCU.

Whirlpool... | Answered on Oct 26, 2019

Hi. You just need to remove two or three screws on the back of the top cover that hold it in place, then slide it yourself the back of the machine and lift. Hope this helps. Good luck.

Whirlpool... | Answered on Oct 25, 2019

Hi. You have to remove the top cover, after removing it you have to reach on the back of the lock switch, there's like a plastic ring that you have to pull up.

Whirlpool... | Answered on Oct 25, 2019

under agitator cogs or plastic gears bad

Whirlpool... | Answered on Oct 19, 2019

check agitator cogs under agitator also check belt under unit or motor

Whirlpool... | Answered on Oct 19, 2019

possible agitator cogs bad or belt under unit or drive motor if voltage to motor bad motor if no voltage to motor bad board

Whirlpool... | Answered on Oct 19, 2019

Search online for the manual for your make and model. It ,may be that a sensor is not working properly.

Whirlpool... | Answered on Oct 18, 2019

Not finding what you are looking for?
Whirlpool WTW6500W Washer Logo

12 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts


Level 3 Expert

85222 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers


Level 3 Expert

411 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Whirlpool Washing Machines

  • Whirlpool Washing Machines

Most Popular Question

washer goes in ol after 14 16 minutes in

  • Washing Machines