Top 20
Kyocera FS1028 Laser Printer Questions & Answers
Call service
You may have gotten an incorrect message and removing and replacing the drum is a step in right direction. But if you continue to get the same message I am afraid you will have to replace the drum - they do wear out.
8/19/2015 10:18:21 AM •
Kyocera FS...
•
113 views • 0 helpful votes
I have kyocera taskalfa 400 take a lot of time to copy 50 sheet ( adding toner )
i replace a lot of kind off the toner
still the proplem
assuming the toner coverage per print isnt excessive , the problem could be any of the following,
toner - have you used 3rd party toner ( compatibles, remanufactured) - if yes - you could have put the developer toner ratio out of spec- fix by replacing developer tank AND toner.
if no - is there any blockage in the toner transfer pipe between toner cartridge and developer tank/ is the pipe split leaking toner if all looks ok , test the toner pump using the service commands., if toner is moving ok the problem must lie in the dev tank - the fix is still to replace the dev tank - good news is its plug and play comes with instructions on fitting and setting up .
1/27/2015 11:09:50 AM •
Kyocera FS...
•
90 views • 0 helpful votes
How do i remove error 4200-0099296
As an error, the C-4200, refers to laser unit. Sometimes the main charge (mc) cause this error. Remove the mc and check the sound of the laser. If you don' t hear the laser sound, then the problem is the laser unit
9/25/2014 8:20:11 AM •
Kyocera FS...
•
162 views • 0 helpful votes
CODE ERROR C7990
This service code means that the waste toner reservoir inside the drum unit is full and that the printer has printed over 100.000 pages.
7/19/2014 3:24:03 AM •
Kyocera FS...
•
987 views • 0 helpful votes
Drum reset procedure kyocera 1300
Unfortunately, you cannot reset the page counter on any kyocera printer. Unless you have an eeprom reader with the appropriate software.
7/19/2014 8:00:10 AM •
Kyocera FS...
•
646 views • 0 helpful votes
Not finding what you are looking for?