20 Most Recent Frigidaire FGHF2366PF French Door Freestanding Refrigerator - Page 10 Questions & Answers

Check or replace theremostat.

On most models, Turning off the freezer turns off whole unit as all cold air comes from freezer

Either the ice maker or water valve is bad. Is there ice in the form?

Good Afternoon Friend, I understand that your Frigidaire refrigerator displays an Sb on your panel. If the numbers are showing Sb, this tells me it is in the Sabbath mode. To get out of this mode you will need to press and hold the down arrow on the freezer side and the up arrow on the refrigerator side simultaneously for 5-10 seconds. If this does not work, I suggest resetting your appliance. You can do this by either unplugging it or shutting the power off at your home's circuit breaker, for 3-5 minutes. Restore power and check the control panel as well as the ice dispenser and lights. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your refrigerator status has changed successfully. Hope this is helpful. -Best Regards- WP

There is no reset button. You can try unplugging for 5 minutes to see if electronics will reset.

nada no

https://www.searspartsdirect.com/partsdirect/user-manuals/fphs2386lf1-frigidaire-parts-manual

you can try notifying frigidaire customer service or will need to order replacement panels

If it’s a defrost problem, entire evaporator will need to be completely thawed. Afterwards, bad defrost components will need to be replaced.

Dear Sue,

• SY CE Error Codes is a very common issue : the display board isn't communicating with the main PCB.
• Unfortunately, there is no way to test which board is causing the problem. That's why this error can be costly.
• Try to just unplug the refrigerator for 15 minutes and plug it back in to see if the error goes away.
• If the issue doesn't go away, then you'll need to replace one or two boards.
• Usually the Main Control Board under the refrigerator behind the kick panel is the part that tends to fail.
• If you Change the Main Board, it does not work; you gonna have to replace the Display Board.
• Try buying these board at an online store that accept Returns without conditions up to a year. Go online and put the boards number into any major search engine. Put the # one by one. You will find many sellers. Carefully pick one and do you homework

Good luck and keep me posted please, JP

Damper between fridge and freezer may be open too much. If it’s manual, just adjust it. If it’s electronic, you made need to call for service. Also could be thermostat related.

Nothing should be watery in a freezer. Check cooling capacity of unit.

Bad ice maker or faulty water valve assuming your freezer is at normal operating temperature

Costly fix. Depends on how old it is. May not be worth repairing.

Inside lower back wall of freezer.

Refrigerant oil leak perhaps. You don’t want to breath that stuff in your home. Need to call licensed technician for inspection or repair. Could also be an old item in your fridge or freezer. Check that in detail before you call the service man.

Side-by-side refrigerators typically have a defrost system that automatically defrosts the freezer periodically. The freezer stops cooling to turn on the defrost heater, but should resume cooling after about an hour. If the timer fails, the freezer will never defrost and ice will continue to build up on the coils, stopping all air glow over the coils. This will prevent the freezer from cooling properly and it will give the impresdion that it's failing. Only the freezer cools, the air is circulated into the refrigerator and cools it (only less so) which gives thd appearance that it's working properly (except it's probably not cooling to the proper temperature of ~40° F.).
The fix is to replace the defrost timer. If you can locate its location on your unit, it usually involves unscrewing and unplugging the old unit and installing the new one. You will need you brand and model number when you get a new one.

Replace door cam kit for freezer side. Water is most likely coming from a stopped up defrost drain

The fan should run with the closed door switch. If you can get to it, does it freely spin? It was correctly reconnected when changed? You did check Voltage on motor? If it is there and motor doe not run, yes it would be bad. Diconected motor can be checked with Ohm meter setting, it should show a circuit.

Evaporator coils should have uniform frost pattern over whole coil. If there is a block of ice only at top, your unit most likely has a freon leak and is low on freon. If whole evaporator coil is a block of ice, then it’s a defrost problem.