20 Most Recent
Kyocera KM-1510 Copier - Page 4 Questions & Answers
The code appears c 610
Hi ;
you should enter the maintenance mode and clear all memory :
to enter Maintenance mode type :
1087 1087
and type : 20 and prss start botton
ERRO E 70 COPIADORA KYICERA MITA 1510
An E70 is as follows:
While using the DF, the last of the ejected originals failed to be copied. Set that original back onto the original table and resume the copying operation.
That is direct from the user manual.
Hope that helps.
Do home copy machines like
No inkjet based machines past or present contain hard drives. They present no storage security risks. The only possible risk would be access to the machine via your network from an outside source. The only data that could be accessed would be fax numbers, names etc.
This would require a major security breach of your network however, and is highly unlikely.
Our Kyocera KM-1510 is making
Hi,
Blank copies are caused by failure in Transfer Corona Assy. It is a thin wire that goes from end to end, you can clean this with a moistened piece of cloth (not too much water) and completely dried and re install again, depending on the type of assembly you have you can also clean the whole thing with a vacuum cleaner as well to remove any toner particles around that might cause some erratic problems on the charging process.
Let us know if you want something else please accept the solution.
Thank You for contacting fixya.com
It has stopped working and is displaying a
Chek toner for Flashing AP
Error C400 polygon motor synchronization problem
1. poor contact in polygon motor connector terminals
2. defective polygon motor
3. defective power supply board or main pcb
HOW TO GET PAGE COUNTER IN kM-1510
Just hold down the stop/clear button for 3 seconds..
It will flash F24 then 3 increments then 3 more.. eg; F24>063>123
It means you have done 063123 copies/prints..
Kyocera KM-1510 when i turn it on the code C-620
Hello sir; You need to do a reset procedure;
press these keys in order and keep hold them down, "stop/reset" "start" "left copy density", press "stop/reset"key again, then enter U163 press "start" twice to clear.
I have on display code J40 what is it mean
this is an error for the jam in the fuser section your hot roller may hav caused a jam or the sensor might be stuck open the side and check the fuser and then the sensor before and after where the papaer comes out
Not finding what you are looking for?