Top 20
Kyocera KM-1505 Copier Questions & Answers
How to solve error c4000 for Kyocera KM-2035 copier? it has stopped
c4000
The Problem:
inside the laser unit Polygon motor synchronization problem
The polygon motor does not reach the
stable speed within 15 s of the START
signal turning on
Causes:
1-Poor contact in the
polygon motor connector
terminals.
Reinsert the connector. Also check for continuity
within the connector cable. If none,
remedy or replace the cable
2-Defective polygon
motor.
Replace the polygon moter or LSU.
How to add powder?
Don't Worry, It's simple ! You Just have to do is:
1)Buy a toner Bottle, its dust and be careful with it.
2) Pull out the toner Cartridge (You know where it is?)
3) There is a small cover with a screws , open it and remove all dust inside.
4) Fill with new ink and screw up the cover,
5) put cartridge back on printer and start.
Enjoy ! write back if any problems.
Black cq when using document feeder
clean the slit glass its the small maybe two inch wide glass to the left of the main glass clean it good use windex or alcohol that will get rid of you problem have a great day
Error code c-6
fuser error cant look at the manual to give you specifics sorry but it is a fuser code
Blinking code c-6
c-6 is usually a heater problem ,bad heat lamp, blown thermal fuse ,or bad thermistor, may have parts at precsion roller .com
Error c6020
this is a fuser error. go into service mode( in the copier standby press 10871087 on the keypad) and go to u163 fuser error reset. If this does not work you might have to consult a service centre.
Code c6020 180
That is a fuser error. Replace the fuser & reset the code in service mode. You will also want to update the firmware of the machine.
Not finding what you are looking for?